搜索资源列表
3.rar
- 利用Matlab中的Simulink工具箱，对单相桥式全控整流电路进行仿真。,Using the Simulink toolbox in Matlab, for single-phase full-controlled bridge rectifier circuit simulation.
JM20330_DATASHEET
- 芯片资料 JM20330 IDE SATA 桥接芯片 data sheet-Chip Information JM20330 IDE SATA bridge chip data sheet
ATMega88+ATA6824
- 基于Atmel ATMega88+ATA682的应用实例 主要功能包括： 1) PWM输出控制 2) H-Bridge,4 POWER FET 驱动 3) 模拟量比较-Based on Atmel ATMega88+ ATA682 the application of the main features include: 1) PWM output control 2) H-Bridge, 4 POWER FET Driver 3) Analog Comparison
CDMAGPRSmodem
- 板上资源： LM2576电源，MAX3232电平转换芯片，11.0592M有源晶振，ATMEGA128L，FM32256（铁电），滑槽式SIM卡座，40PZIF接插件，通信 模块支持CM320,TC35i，MC35i，MC39i，GTM900A/B等模块。 使用方法：1、不焊接M128和FM32256以及晶振，将桥接电阻R29,R30,R31焊上，就是标准串口无线MODEM，根据模块不同可以支持GPRS和CDMA， 当然也可以作为GSM猫或者短信猫来使用。 2、焊上M
vme_univ_3.3
- universeII驱动，用做vme总线和pci总线的桥接-universeII driver，used as the bridge of vme bus to pci bus
stm32_3usart
- stm32f103v8 3 串口测试 9600波特率, 实现串口桥接转发-stm32f103v8 3 usart test at 9600bps, for uart bridge
3
- 利用Matlab中的simulink工具箱仿真。单相桥式PWM逆变电路，采用单极性触发方式，负载 ，电源 ，建立模型，制作PWM触发模块，画出基波幅值与占空比关系图。-Using simulink toolbox of Matlab simulation. Single-phase PWM bridge inverter circuit, the use of unipolar trigger mode, load, power, establishment of model, trigger
nethidpro-3.0.7.tar
- NethidPro 3.7 加密网桥 For linux-NethidPro 3.7 network bridge For linux
xapp737
- xapp737 from xilinx website : SPI-4.2 to Quad SPI-3 Bridge in Virtex-4 FPGAs
xapp525
- xapp525 from xilinx website: SPI-4.2 to Quad SPI-3 Bridge
fullControlledrectifier
- 3-phase fully-controlled bridge rectifier circuit is described in this model that is simulated in matlab/simulink-3-phase fully-controlled bridge rectifier circuit is described in this model that is simulated in matlab/simulink
3
- 谈谈交流电桥及其应用，作者：QQ 64134703 ，欢迎咨询-Talk about the current bridge and its application, of: QQ 64134703, welcomed the Advisory
1
- Simulating a 3 phase thyristor rectifier bridge as voltage source
Wheatstone-Bridge
- 惠斯通电桥（又称单臂电桥）是一种可以精确测量电阻的仪器。图3－13所示是一个通用的惠斯通电桥。电阻R1，R2，R3，R4叫做电桥的四个臂，G为检流计，用以检查它所在的支路有无电流。当G无电流通过时，称电桥达到平衡。平衡时，四个臂的阻值满足一个简单的关系，利用这一关系就可测量电阻。-Wheatstone bridge (also known as Wheatstone bridge) is an instrument that can accurately measure resistance.
PMSM_3HP_drives
- This circuit uses the AC6 block of SimPowerSystems™ library. It models a permanent magnet (PM) synchronous motor drive with a braking chopper for a 3HP motor. The PM synchronous motor is fed by a PWM voltage source inverter, which is built us
caif_shmcore
- Helper functions for the SPI-3 bridge FPGA on the Radisys ENP2611.
New-folder-(3)
- truss solver with bridge
caif_shmcore
- Helper functions for the SPI-3 bridge FPGA on the Radisys ENP2611.
3相SPWM
- 输出3相spwm波形，可驱动三相桥，包含完整工程及源码(3 phase SPWM output waveform, can drive three-phase bridge)
test 3-bridge
- 简易三相电路，验证三相电源abc端口顺序及测量元件工作方式。(A simple three-phase circuit is used to verify the ABC port sequence of the three-phase power supply and the working mode of the measuring element.)