搜索资源列表
在Unix系统中利用程序实现Kill命令
- 程序的功能是根据终端号杀死进程并激活终端,操作上只要在另一台终端上执行 killtty ttyname即可,其中ttyname 是需要激活的终端号-procedures function is based on the terminal, killing process and activation terminals, as long as the operation in another terminal can be implemented killtty ttyname, ttyname
c-s-connect
- linux下,以CS结构建立的通讯机制,包括服务器端和客户端,包括IP,端口等处理以及绑定,代码设计成启动的时候手动输入IP,适用强,为了避免80端口被占用,所以端口也设置成手动,用的时候请注意-under linux to CS structure established communications mechanisms, including the server-side and client, including IP, port, such as processing and bind
aodv
- Hi to administrator i am student so i m requesting you to accept my code and activate my account i want source code of aodv to run on omnet++
telnetd.tar
- tiny scr ipt to activate telnetd in DCS-3411 series
ht6560b
- HT-6560B EIDE-controller support To activate controller support use kernel parameter "ide0=ht6560b".
lmv_obd
- lmv activate target for Linux.
ide-dma-sff
- attempt to activate IDE DMA @drive: the drive to place in DMA mode.
nes_nic
- nes_netdev_open - Activate the network interface ifconfig ethx up. -nes_netdev_open - Activate the network interface ifconfig ethx up.
go7007-priv
- IDs to activate board-specific support code.
mgag200_cursor
- Hide the cursor off screen. We can t disable the cursor hardware because it takes too long to re-activate and causes momentary corruption.
ht6560b
- HT-6560B EIDE-controller support To activate controller support use kernel parameter ide0=ht6560b . Use hdparm utility to enable PIO mode support. -HT-6560B EIDE-controller support To activate controller support use kernel parameter ide0=ht6560b .
mgag200_cursor
- Hide the cursor off screen. We can t disable the cursor hardware because it takes too long to re-activate and causes momentary corruption.
port_kern
- Either disconnect one to make it available or activate some more -Either disconnect one to make it available or activate some more
malta-setup
- Activate Floppy Controller in the SMSC FDC37M817 Super I O Controller. Done by YAMON 2.00 onwards.
rtl819x_BAProc
- Activate BA entry. And if Time is nozero, start timer.
Feature
- TODO: Move this to activate Used for changing the resolution getUserMode will get the preferred mode set thru adb shell.
Partitions
- Uncomment the line below if you want to activate sub-pixel rendering.
u_debug_memory
- Uncomment the line below if you want to activate sub-pixel rendering (a.k.a. LCD rendering, or ClearType) in this build of the library. -Uncomment the line below if you want to activate sub-pixel rendering (a.k.a. LCD rendering, or ClearType) in t
decompress
- activate the code for pre-boot environment.
on_item
- Descr iption: Turn on (activate) menu item.