搜索资源列表
uart(Verilog)
- RS232的verilog源代码,如果需要的可以
uart
- 基于MAXII的RS232串口通信程序.还有使用VB编写的上位机串口通信软件。
FPGA-RS232-verilog
- fpga上的串口驱动程序，包括接收主机来的数据（deserial）和发送由FPGA产生的数据(serial).该程序的调试需要借助串口调试助手-serial port driver on the fpga, including the receiving host to the data (deserial) and send the data generated by the FPGA (serial) to pc. The program needs the serial debug deb
Template
- C8051F120的串口通信，有命令格式，有超时检测，有校验和功能，使用了PLL提升了系统频率。经过测试。有端口和使用说明文件，工程文件完整，移植方便。使用下面的功能：UART RS232 PLL GPIO Timer-C8051F120 serial communication, a command format, a time-out detection, a checksum function, use the PLL to enhance the system frequency. Te
UART
- 内含有完整的UART代码，包括发送和接受，且有testbench，可以直接仿真调试-Contain complete UART code, including send and receive and there testbench, can directly Simulation debugging
UART
- UART配置接收数据，用c编写，有注释，连接rs232-UART configured to receive data, with c prepared annotated connecting RS232
uart
- 串口通讯rs232,时钟频率为40Mhz,波特率为19200,没有奇偶校验,在xilinx XC3S200A板子上验证过.-Serial communication rs232, clock frequency of 40Mhz, the baud rate to 19200, no parity, in the board on xilinx XC3S200A verified.
449_232_OK
- RS232 UART模块 调通 有中文解释-RS232 UART module has the Chinese interpretation of tune
uart_zhiwen
- RS232的UART编程，包括波特率发生器模块，串口接受模块，串口发送模块-RS232 programming the UART, including the baud rate generator module, serial module to receive, send serial module
RS232
- files describe a example tranmister a txt by uart from host PC and select baud rate
display_7seg
- 串行口uart-rs232不带缓冲器区的显示模块，望大家给与意见-Uart-rs232 serial port with no buffer zone display module, hope you give advice
UART
- 用于PC机与C6416DSP之间的RS232串口通信-For the PC, and RS232 serial communication between C6416DSP
com_tool
- uart通信串口调试工具，目前较为常用的串口有9针串口（DB9）和25针串口（DB25），通信距离较近时(<12m)，可以用电缆线直接连接标准RS232端口(RS422,RS485较远)，若距离较远，需附加调制解调器（MODEM）。最为简单且常用的是三线制接法，即地、接收数据和发送数据三脚相连，本文只涉及到最为基本的接法，且直接用RS232相连。 -uart communication serial debugging tools
RS232
- simple example for uart on fpga
01_uart_232
- uart,RS232 mcu to computer
usb-uart
- Datasheet USB to UART (RS232)
Verilog_RS232(Uart)
- 用verilog编的rs232，uart串口程序，很好用-a program about rs232 with verilog
UART_FOR_Altera
- 用于控制3个独立的全双工传输的UART/RS232接口。该接口由Altera SOPC 实现，开发环境为NIOS II。在Statrix II上工作正常。 每个接口可独立配置为短数据模式和数据流模式。-This C source file is used for controling three UART/RS232 interfaces . These interfaces are implemented by Altera s SOPC module , assembled in a S
uart
- 实现与PC的串口通信,实验验证过其功能正确-Communicate with RS232 on PC
lab-uart
- verilog RS232 讀取跟寫入和傳送資料-verilog RS232 with write and read data transfer