搜索资源列表
WIM2_3D_ant_ver064_220908
- for 3GPP wireless ratio channel system
8
- 8单径瑞利信道中的四发四收V-BLAST： (1) 请设计一种具体的导引辅助的信道估计方法，用Simulink进行仿真，测量16QPSK调制时的误码率性能。画出比特信噪比与信道估计均方误差的关系曲线，画出比特信噪比与误码率的关系曲线。 (2) 计算所设计方案的频谱效率是多少，单位为bit/Hz/s。-8 Single-Path Rayleigh Channel Four received four V-BLAST: (1) Please design a specific guide-a
87361015MIMO_OFDMsystem
- 这是关于ofdm-mimo的一段小程序，能运行出来，得出几个信噪比的图-This is on ofdm-mimo' s a small program that can run out of plans to draw a number of signal to noise ratio
MIMOMRC
- MIMO MRC system - maximum ratio combining-MIMO MRC system- maximum ratio combining
vblast_sim
- VBLAST系统仿真，针对时变信道的自适应调制算法-erq.m : function for simulating ERQ algorithm with Gap parameter sqpc_g.m : function for simulating SQPC algorithm with Gap parameter sr_g.m : function for simulating SR algorithm with Gap parameter vblast_rate.m : fun
CISQPSK
- 采用重要性采样的方法来代替蒙特卡罗仿真方法，确定数字通信系统的BER。重要性采样方法可以简单的增加信道噪声的方差，等效于使系统工作在一个较低的信噪比的环境下。-Using importance sampling method to replace the Monte Carlo simulation method to determine the digital communication system BER. Importance sampling method can be a simpl
SIMULATION
- Linear time varying Channel estimation using zero forcing algorithm describes bit error rate and signsl to noise ratio to analyse channel conditions of wireless communications
LCT
- 两折线法抑制峰均功率比，通过对原始OFDM信号和LNST方法进行CCDF仿真分析。-Two-line method for suppressing the peak to average power ratio, by the original OFDM signal and LNST method CCDF simulation.
turbo-lte
- 3G 长期演进技术的LTE里边Turbo编解码，信道模拟，信噪比分析等-3G Long Term Evolution LTE technology inside Turbo decoding, channel modeling, signal to noise ratio analysis
link-simulation
- 协作中继系统链路级仿真，里面对信噪比，误码率，BER性能仿真实现-Link Simulation cooperative relay system, which on the signal to noise ratio, bit error rate, BER Performance Simulation
channel-simulink
- 衰落信道幅值仿真编程：对瑞利衰落信道进行仿真，并加上高斯白噪声，通过输入不同的信噪比 比较其误码率变化-Amplitude fading channel simulation programming: on the Rayleigh fading channel simulation, and add white Gaussian noise, by entering a different signal to noise ratio to compare their error rate ch
SM_VBALST_MRC
- SM、V-BLAST、MRC系统仿真比较 SM、V-BLAST、MRC系统6bits传输仿真结果-Normalized maximum ratio combining (NMRC) detection algorithm, NMRC algorithm for general channels, flat fading channel Tan Ruili, Gaussian white noise, the receiver has received a perfect channel stat
SCFDMAmatlab
- 给出很详细的LTE中上行链路的SC-FDMA仿真信噪比，经验证可以运行。-Given in great detail LTE uplink SC-FDMA signal to noise ratio simulation, validated to run.
PTSandClippingtoReducePAPR
- PTS与限幅结合降低OFDM峰均比的改进算法.提出了一种基于部分传输序列（PTS）算法和限幅算法相结合的改进算法来降低正交频分复用（OFDM）系统的峰均功率比（PAPR）。-Improved Algorithm of Combination of PTS and Clipping to Reduce PAPR in OFDM System In this paper, an improved algorithm is proposed based on Partial Transmit Se
PTSandPeak-cancellation
- 基于 PTS 级联抵消的峰均比抑制性能仿真.提出了 PTS 级联抵消算法，实现对地面数字多媒体广播系统中时域同步正交频分复用信号的峰均功率比的抑制-Simulation on PAPR Improvement Based on Joint Scheme of PTS and Peak-cancellation. New joint scheme of partial transmit sequence (PTS) and peak-cancellation technique was pro
LTE_common_calculate_SC_SNR
- LTE TDD 单载波信噪比计算（Matlab代码）-LTE TDD single-carrier signal to noise ratio calculation (Matlab code)
ofdm_lyl
- OFDM系统，包含QPSK星座映射、串并转换、IFFT变换、加保护间隔、求峰均比等。-OFDM system with QPSK constellation mapping, a serial-to-parallel conversion, IFFT transform, plus guard interval requirements such as peak-to-average ratio.
CandSNR
- MIMO虚拟技术信道容量随信噪比的变化关系图像，MATLAB仿真程序，源代码-Virtual MIMO channel capacity with the signal-to-noise ratio of the change in the relationship between image, MATLAB simulation program, the source code
Digital-system-
- 数字基带传输系统 代码 眼图 误码率 a=0.5 tao=Ts/2 phi=0。信噪比15，采样偏差0，滚余弦系数0.5，占空比0.5，-Digital baseband transmission system bit error rate of the code eye diagram a = 0.5 Tao = Ts/2 phi = 0. Signal-to-noise ratio 15, the sampling deviation, roll cosine coefficient
new1
- clc clear number of subbands K = 32 oversampling ratio O = 2 decimation rate D = K/O number of taps per polyphase component P = 3 total prototype filter length is L = D*P prototype filter-clc clear number of