搜索资源列表
timer
- 用于arm2410开发系统，使用时间中断产生脉冲信号，可测试系统可测试的最短信号-for arm2410 development system, the use of time interrupt pulse signal test system may be the shortest test signal
aic10+5402
- c5402+aic10的codec程序，语音信号的处理可以使用-c5402 aic10 the codec procedures, the voice signal processing can be used
44b0_PS2_KeyBoards
- 44BO作为PS/2主机端与普通PC键盘通信源程序，可以接收任何键盘信号，但是不能发出键盘控制信号以控制键盘指示灯亮灭，对PS/2键盘感兴趣的朋友可以和我联系。-44BO as PS / 2 host side and ordinary PC keyboard communication source, the keyboard can receive any signal, but not issued keyboard control signals to control the keybo
maichong
- 三端口输入，同步脉冲信号检测器，精确实现输入信号的定位-three port inputs, synchronous pulse signal detector, the input signal to achieve precise positioning
armADCtest
- 基于S3C44B0X微处理器,通过A/D转换器读入模拟信号伏值,对ADC进行测试-S3C44B0X based microprocessor, the A / D converter read analog signal volts value, the ADC test
AnteeoBee_20060218
- his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run \"make\" from the console in echomaster and ech
pi06_src
- at91rm9200双端口RAM驱动及测试程序，支持信号量抢占，支持连续读取及重定位。-at91rm9200 dual-port RAM drive and testing procedures, the volume seize signal support, support for reading and re-positioning.
DDSCtrl
- 基于HMS7202的波形发生器源程序，采用ADS8237芯片，能够产生100MHz以内的任意波形信号-HMS7202 based on the source waveform generator using ADS8237 chips, to produce 100 MHz within the arbitrary waveform signal
aduart
- MC13213接受AD采集信号并发送到串口进行接受的程序，-MC13213 accept AD Acquisition signal sent to the serial accept the procedure,
application1
- 在labview环境下开发的用于位移测量的应用程序。其中包含了usb采集卡数据采集，信号调理，以及report for microsoft office的应用-the PC environment for the development of the displacement measurement applications. Which contains the usb acquisition card data acquisition, signal conditioning, and th
source_demo_stV0288_ix2476_V0_05_
- 通过PC并口模拟I2C信号，编写sharp stV0288 芯片驱动，在VC++环境下编译通过。-PC parallel port through I2C signal simulation, prepared sharp stV0288 chip-driven, the VC environment compile.
i2csoft
- I2C signal control by software
Research_on_Wind_Farm_Modeling
- 本文对风电场—无穷大系统进行了简单的仿真分析，主要包括小干扰稳定分析，风电场的并网、负荷扰动以及联络线故障时的暂态分析。然后以达里风电场所在系统为例，在稳态分析和暂态分析的基础上计算风电场允许接入最大容量。 -In this paper, Wind Farm- infinite simple system simulation analysis, including small signal stability analysis, wind farm and the net tie-line
DEC2812
- TMS320F2812源程序 based on the Texas Instruments TMS320F2812 Digital Signal Processor.-TMS320F2812 source based on the Texas Instruments TMS320F2812 Digital Signal Processor.
51--signal-analysis--FFT
- 51单片机，信号分析，FFT,8位单片机进行信号分析的尝试-51, signal analysis, FFT, 8-bit microcontroller attempt to signal analysis
msp430-sweep-signal
- msp430产生扫频信号并识别输入信号频率-msp430 sweep signal and generates the input signal frequency identification
USB-ad9854-signal-generater
- usb ad9854信号发生器，固件为单片机程序，上位机软件，分别使用keil 和vc 6-usb ad9854 signal generator, the program for the microcontroller firmware, PC software, respectively, using keil and vc 6
Sweep-Signal-Generator
- Sweep/Signal Generator LPC2138
PC104--timing-signal
- pc104总线时序信号简介以及各个引脚信号定义，大家可以参考下-pc104 timing signal
signal-generator128
- 基于STM32F103的函数信号发生器，含有正弦波，三角波，方波，锯齿波等-Function signal generator based on STM32F103, contain a sine wave, triangle wave, square wave, sawtooth wave, etc...