搜索资源列表
CYCLONEIISCH
- ALTER公司CYCLONEII系列NIOSII开发板原理图，32位可裁减资源单片机在片设计。-ALTER company CYCLONEII series NIOSII development board diagram, 32 MCU resources can be trimmed in film design.
sst39vf400
- /* Check_SST_39VF400A Check manufacturer and device ID /* CFI_Query CFI Query Entry/Exit command sequence /* Erase_One_Sector Erase a sector of 2048 words /* Erase_One_Block Erase a block of 32K words /* Erase_Entire_Chip Erase the contents o
CE122_ADC_AltSamp_091207
- Alter among different sample channels when using A/D for dspic programming.
ISPDownload
- Alter、ARM、AVR、S51等ISP下载线制做的原理图与PCB图。
mA2DC-SCH+PCB
- mA电流转换成电压的电路SCH+PCB，可转换4~20mA的电流，改变电阻可改变转换范围。文件为Protel DXP 2004-mA current into a voltage circuit SCH+ PCB, can be converted 4 ~ 20mA of current, resistance to change can alter the scope of the conversion. Protel DXP 2004 documents
oracledump
- There are three ways of specifying an immediate dump Immediate dumps can be specified using the ALTER SESSION command ALTER SESSION SET EVENTS immediate trace name dump level level Immediate dumps can be specified in ORADEBUG ORADEBU
1
- 在一拖三循环变频控制系统中实现三台泵的换机过程-implement of the process of alter dump at cycle frequency conversion systems.
clock
- 这是一个电子表，基于51单片机，1602液晶显示，可以手动对时。-This is a program functioning as a digital watch. You can alter its time by hand.
uart
- ARM的P0.0口接LED，串口接Proteus的虚拟终端。每隔一段时间改变一次LED的状态，并且在串口上输出LED的当前状态。-LED contact the port P0.0,and uart port contact the Proteus virture terminal . alter the LED state every a time,and output the curent state to the termial.
timer3
- 在KEIL4环境中，用定时器3准确定时一段时间，这个程序是定时10ms，可以通过更改分母，来改变定时时间-In KEIL4 environment, using timer 3 accurately timed period of time, this program is timed 10ms, the denominator can be changed to alter the regular time
lcd12864
- LCD12864驱动，该文件包含12864驱动，可直接修改使用-LCD12864 driver, the file contains 12864 drive, can be used directly alter the
WPA_MR09
- 使用此源码请首先确认拿到的开发板为MR08（WM631 8688） 模块 还是MR09（8686）模块。然后根据自己开发板的模块类型，到xxxconfig.h中修改源码配置为模块相应的固件版本。-Please confirm whether your DEV-tool is MR08(WM631 8688) or MR09(8686).then alter the configuration in xxxconfig.h depend on the type of your DEV-tool.