搜索资源列表
MAX6675LCD
- K型热电偶信号转换放大器MAX6675的驱动设置程序。该程序能控制MAX6675对K型热电偶的微弱信号进行放大、AD转换。-K-type thermocouple signal converter amplifier MAX6675 driver setup program. The program can control the MAX6675 on the K-type thermocouple of weak signal amplification, AD conversion.
an844
- Thermocouple this is to interface k type thermocouple
wenduceshi
- 本设计采用镍铬/镍铝热电偶，此电偶用于0℃～1000℃的温度测量范围，相应的输出电压为0mV-41.32mV.超出温度范围报警-This design uses nickel chromium/nickel aluminum thermocouple, this power, even for 0 ℃ ~ 1000 ° C temperature measurement range, the corresponding output voltage 0mV-41.32mV The range t
16-8Ng2
- 用C语言编写的MSP430F425热电偶测温程序，内有铂电阻补偿程序和实测温度校正程序，多年使用后，稳定运行，没有出过问题。-Using C language MSP430F425 thermocouple procedures, which are measured platinum resistance temperature compensation procedures and calibration procedures, after years of use, stable oper
PID_data
- PID模拟。这个模拟主要是针对MARLIN固件中对热电偶的温度控制模拟。-PID simulation. This simulation is mainly for MARLIN firmware thermocouple temperature control simulation.
MAX6675-driver
- driver for the MAX6675, a chip which interfaces to a K-type thermocouple over a simple SPI bus. The driver implements a software SPI port, so there is no need for dedicateed hardware- any 3 GPIO pins can be used.
max6675
- driver for the max6675 thermocouple in PIC CCS
DS18B20-Thermocouple-env_temp-linearization
- DS18B20 Thermocouple env_temp linearization