搜索资源列表
an184sw
- his header file that is used to define all preprossor directives, global variables, and prototypes. The user must modify this header file for their particular Bridge Transducer in use before proceeding.
wenduji
- 用热电阻Pt100做温度传感器，采用惠斯登电桥测量电路，将随温度变化的热电阻变化量转换成模拟电压信号；用LM324设计放大电路；以12位串行模数转换器ADS7816将模拟电压信号转换成为数字信号；单片机将采集到的数字信号经过平滑处理、变换成温度量用数码管显示出来。-To do with hot 电阻 Pt100 temperature sensor, the use of Wheatstone bridge measurement circuit, the temperature depende
PV_2407_1K5
- 1.5Kw光伏并并网逆变器汇编程序，最大功率跟踪，boost加全桥，基于DSP2407-1.5Kw photovoltaic grid-connected inverter assembly program, the maximum power point tracking, boost plus full-bridge, based on DSP2407
spwm
- SPWM汇编源代码。解决了逆变电源桥臂的控制问题-SPWM source code compilation. Solve the power bridge inverter control arm
exam3_2
- 采用平面梁单元计算斜腿刚架桥的变形和内力!!!!!!!!!!!!1-Inclined plane beam element calculations using legs just bridge the deformation and internal force !!!!!!!!!!!! 1
try4
- this the complete source code for switching for single phase bridge inverter...pic16f84a is used as the controller of the switching inverter-this is the complete source code for switching for single phase bridge inverter...pic16f84a is used as the co
fifo
- 本程序利用fifo实现缓存，可用于多种高速采集芯片的桥接，从而实现高速的采集系统-The program utilizes fifo cache and can be used for a variety of high-speed data acquisition chip bridge, in order to achieve high-speed acquisition system
sanxiangbanbo
- 单相桥半波逆变电路的simulink仿真图-The simulink simulation diagram of the half-wave single-phase bridge inverter circuit
CHBthrsevenleRABC
- 级联H桥三相七电平matlab仿真模型，分享供大家使用-Cascade H-bridge three-phase seven-level Matlab simulation model to share for everyone to use
puenteh
- This program is intended for making a H Bridge, so you can make a power inverter with 60Hz frequency or you can modify it for controlling a electric motor backward and forward
the-stress-of-a-bridge
- ansys模拟桥梁受力分析，在桥上有车行驶过时计算出桥梁不同部位受力状况及挠度变化值。-ansys stress analysis simulation bridge, a car traveling on the bridge obsolete bridges in different parts of the calculated force status and changes in the value of deflection.
Measuring-Delay
- 考虑你在哪里不同的传感器，桥上两侧的汽车造成的振动记录收集数据的情况。当你分析这些信号，则可能需要对齐。假设你有3个传感器以相同的采样速率工作，他们是造成同一事件的测量信号。-Consider a situation where you are collecting data different sensors, recording vibrations caused by cars on both sides of a bridge. When you analyze the signals
danxiangqiaoquankong
- 单相全控桥整流电路电阻负载的MATLAB模型，已经完整搭建，并且仿真处完整的波形。-Single-phase full-controlled bridge rectifier circuit MATLAB model resistive load, has been completely set up, and complete simulation of the waveform.
danxiangqiaoquankongRL
- 单相全控桥整流电路阻感负载的MATLAB模型，已经完整搭建，并且仿真处完整的波形。-Single-phase full-controlled bridge rectifier circuit resistance of the inductive load MATLAB model, has been completely built, and the simulation of the complete waveform.