资源列表
fec
- 蓝牙模块的2/3FEC接口函数，在CCS环境下编译通过。-2/3FEC Bluetooth module interface function, the CCS environment compile.
Class_definition_file_FIR_Filter
- FIR滤波器的C++实现 Below are program source listings for FIR.h and FIR.cpp, the header file and class file for implementing arbitrary causal FIR filters in the Synthesis Tool Kit (STK) framework
1602watch.rar
- 自己写的三按键电子表程序，51单片机，1602字符液晶，已调试正确，可根据具体应用修改端口即可。,Write their own three-button electronic program table, 51 single-chip, liquid crystal 1602 characters have been the right debugger can be modified according to specific application port.
et6202
- et6202控制2*10键盘，LED数码管显示从0到9依次扫描显示-et6202 Control 2* 10 keyboard, LED digital tube display from 0-9 followed by scanning display
FLASH
- 该程序用于对C6416开发板中FLASH的读写是否成功的验证 -The program for the development of the C6416 board FLASH verify the success of reading and writing
uscia0_uart_9600
- msp430f247对串口的操作，测试能用-msp430f247 of serial operation, the test can
leer_serial_multi
- data aquisition from atmega 328p mcu to matlab via usb interface
trans--English
- 基于TC35i的远程温度报警系统设计中，发送英文信息的，C51编写的程序，通过验证的，用的时候需要把电话号码改一下-TC35i based on the remote temperature alarm system design, send English information, C51 program, through the verification, when using, need to change your phone number
traffic_Light
- 模拟十字路*通灯的VHDL程序，附有用与配合ModelSim的仿真程序。 内容：交通灯设计 （1）A，B方向各有红，黄，绿灯，初始态全为红灯，之后东西方向通车，绿灯灭后，黄灯闪烁，各路口通车时间为30秒，由两个七段数码管计数，当显示时间小于3秒的时候通车方向黄灯闪烁 （2）系统时钟1KHz，黄灯闪烁时钟要求为2Hz，七段码管的时间显示为1Hz脉冲，即1秒递减一次，在显示时间小于3秒时，通车方向的黄灯以2Hz的频率闪烁，系统中加入外部复位信号。 （3）用ModelSim做仿真
xin
- 利用单片机与电脑之间通过数据传输来实现智能灯控制程序-Intelligent light control program through the data transmission between the microcontroller and the computer
1062
- 单片机51 1062液晶显示程序。。。驱动一类-MCU 511 062 LCD program. . . To drive a class
led
- 基于单片机开发设计单列LED显示模块，以时移控制LED输出内容，通过人眼的视觉暂留效应，在LED转动区域产生一个扇形视觉平面，从而达到在该视觉平面上传达信息的作用，实现广告信息显示。系统可通过232通讯接口更新显示内容。 -Based on MCU development and design single LED display module to the time shift control LED output by the human eye persistence of visio