资源列表
AVRBoot_M8
- atmega8的BootLoad程序，需写入M8之中,现已在Atmega8芯片上测试通过。我已使用它做了几个项目，除第一次使用下载线，以后写片子只用串口线.-atmega8 BootLoad the procedures required to be included in M8, which is available at Atmega8 chip test. I have to use it to do several projects, in addition to the first u
13898356CAN_TEST
- usbcan的人机交互编程vc例程，嵌入式可以参考。
lcd1602
- lcd 1602使用程序 调试过 可放心使用-lcd 1602 over the use of program debugging can be assured the use of
ARM7_stepmotor
- ARM7驱动步进电机的程序 -ARM7_stepmotor.txt
motorPWM
- 用Ｃ语言编写的驱动电机的程序 调试通过的 直接可以用 ５１环境-Using C language debugging drive motor can be used directly through the 51 environmental
bit
- 可实现对凌阳spce061a进行单个管脚进行操作的头文件，本人已在lcd1602的控制中使用过-Sunplus spce061a can be realized on a single pin to operate the first paper, I have been in control of lcd1602 used
ds18b20
- 基于MCS-51的温度测量程序 温度程序-MCS-51 based on the temperature measurement procedure
MPLAB_C18_interrupt
- MPLAB C18 不自动把中断服务程序放在中断向量处。通常将GOTO 指令放在中断向量处，从而把控制权转交给相应的中断服务程序 PIC18系列的低优先级中断入口地址在0x0018地址，下面的代码是在入口地址处放置一个向量函数，这个向量函数里就是一个内嵌汇编的GOTO指令，GOTO到低优先级的中断服务函数InterruptHandlerLow。-MPLAB C18 does not automatically interrupt service routine on the inte
dianzizhong
- 电子钟 基于单片机的课程设计的程序 通过编译软件和烧写软件来实现与单片机上- Electric clock Based on SCM curriculum design program compiled by software and burning software to realize and MCU
24c02
- 有关51单片机读写AT24C02的C语言程序，需要的下-For read and write AT24C02 MCU 51 of the C language program, required under the
JIAN
- 单片机的时钟程序。可以实现四位数码管的时分秒的显示。-MCU clock program. Can be achieved when four digital tube display minutes and seconds.
Hardware
- Hardware driver for LCD