资源列表
BUFG_CLKDV_SUBM
- xilinx DCM 应用程序，完全可用-xilinx DCM applications, fully available
4by4
- 4输入，4输出，clos网络所用，有利于连接处理器和处理器，处理器和存储器传输数据。-4 inputs, 4 outputs, clos network use is conducive to connecting the processor and processor, processor and memory to transfer data.
attachments_15_02_2011.
- barrel shifter in vhdl coding
key_led
- _key_led_without_debounce 轻触开关S1~S4 控制LED 亮灭，无按键去抖-_key_led_without_debounce touch switch S1 ~ S4 control the LED light off, no key debounce
DataMemory
- datamemory code in verilog for pipeline processor
led
- 时钟定时器C语言源代码。用于DSP和各种仿真软件。-Clock timer c language code
8155-timer
- 该程序是 8155定时程序，该程序是由汇编语言编写，可在单片机最小系统上运行。-The program is the 8155 regular program, the program is written in assembly language can be run on the smallest single-chip system.
main
- 用51控制mcp2515发送报文，已经通过验证-The 51 control MCP2515 send packets
TimerA3(2)
- msp430F149,说明：拨动P3.4使用软件和TA_0 ISR。Timer_A的配置模式，定时器溢出时TAR计数到CCR0。在这个例子中，CCR0装有20000。-Descr iption: Toggle P3.4 using software and TA_0 ISR. Timer_A is configured for up mode, thus the timer overflows when TAR counts to CCR0. In this example, CCR0 is l
liushuideng
- 用C语言编写的流水灯程序，可以用于C51单片机的开发-C programming language running water light
slm
- this the program for finding peak power in ofdm using selective mapping-this is the program for finding peak power in ofdm using selective mapping
PWM
- 恒速电机，通过本例程了解程序的工作原理，单片机初学者的必备程序-Necessary procedures constant speed motor, through this routine to understand the procedure works, SCM beginners