资源列表
485
- 自制的云台控制器的接收部分，指令经过485总线接收后，解释自己定义的协议，控制交流电机旋转-PTZ Controller made the reception of the 485 bus after receiving instruction, the definition of an agreement to interpret its own, control AC motor rotation
key
- c语言编写51单片机，4*5键盘驱动，已测试-4×5 keyboard driver
fengmingqi
- 同时用两个定时器控制蜂鸣器发声， 定时器0控制频率，定时器1控制同个 频率持续的时间，间隔2s依次输出 1，10，50,100，200,400,800, 1k（hz）的方波? 设晶振频率为12MHz。-At the same time the buzzer sound with two timers, Timer 0 control the frequency of Timer 1 control with a frequency, duration, interval 2s
huarenyidianzichengxu
- 利用8051单片机和12864液晶画直角坐标系-Use 8051 and 12864 LCD picture Cartesian coordinates
LED-TEST
- to glow led in led matrix
dzz
- 以单片机为核心器件，以软件为驱动，来控制数码管。-A microcontroller as the core component of software-driven, to control the LED.
NixieTube
- 多位数码管驱动代码，代码精简，只有30行左右，改动函数参数即可实现1到5位数码管选择显示以及小数点显示位置。-Many LED driver code, code simplification, only 30 lines or so, change the function parameters can be realized 1-5 LED display and select the decimal point display position.
led
- 用51单片机点亮一个led灯，调试可用,keil2调试-MCU with 51 lights led lights, debugging can be used
main
- 用51控制mcp2515发送报文，已经通过验证-The 51 control MCP2515 send packets
TimerA3(2)
- msp430F149,说明：拨动P3.4使用软件和TA_0 ISR。Timer_A的配置模式，定时器溢出时TAR计数到CCR0。在这个例子中，CCR0装有20000。-Descr iption: Toggle P3.4 using software and TA_0 ISR. Timer_A is configured for up mode, thus the timer overflows when TAR counts to CCR0. In this example, CCR0 is l
liushuideng
- 用C语言编写的流水灯程序，可以用于C51单片机的开发-C programming language running water light
PWM
- 恒速电机，通过本例程了解程序的工作原理，单片机初学者的必备程序-Necessary procedures constant speed motor, through this routine to understand the procedure works, SCM beginners