资源列表
ADC10
- msp430F2274的adc10功能转换程序，内含dtc的设置，通过iar调试通过。-adc10 function of msp430F2274 the conversion process, including setting dtc through debugging through iar.
xt3
- 编写串口通信程序，要求PC机先发送02H，单片机发送“HELLO”，如果PC机发送55H，单片机发送“THIS IS A WELL BEGIN!”-Procedures for the preparation of serial communication, PC-request sent to 02H, single-chip microcomputer to send "HELLO", if the PC sent 55H, single-chip microcomputer Send "T
TEST
- 通过矩阵键盘输入，液晶1602或是12232显示某特定值-tongguojuzhenjianpanshuru，yejing1602 or 12232 display
DA
- 10位DATLC5615通过设定可以设定想要输出的电压-10 DATLC5615 by setting the desired output voltage can be set
PIC16F887--PWM-with-50khz
- 单片机16f877输出方波 50HZ 可以根据自己的使用调节脉宽和频率-Microcontroller 16f877 50HZ output square wave can be adjusted according to their width and frequency of use
main
- 主要功能是实现单片机的串口通信方便在程序调试的过程中可以通过串口助手观察结果。-SCM' s main function is to facilitate serial communication process of debugging assistant through the serial port observations.
time
- 自己写的用定时器做的实时时钟程序，在6位数码管上显示-Write their own real-time clock with a timer to do the program, the six LED display
matrix_key
- 基于c51单片机的led灯流水式显示，代码清晰简洁，方便学习-C51 microcontroller based led lamps water display, the code clear and concise, easy to learn
xianshi
- 用单片机实现 按键功能 一次按下16个键 分别显示1到16的平方-With the single chip microcomputer keys function a press and a key respectively show 1 to 16 square
RS232_display
- RS232为串口输出，程序实现对RS232读入和读出-RS232 serial output, the program RS232 read and read-out
main
- 430F149单片机用从P2.3和P2.4输出的PWM波形驱动LED闪烁P2.3口输出方波的占空比为75 P2.4口输出方波的占空比为25 -430F149 microcontroller P2.3 and P2.4 output from the PWM waveform drive LED flashes P2.3 port output square wave of duty cycle 75 P2.4 port output square wave of 25 duty cyc
10.c
- 液晶屏驱动程序，PIC MAPLAB环境仿真通过，Protues仿真也可以-LCD driver,simulate by MAPLAB and Protues