资源列表
FFT.rar
- FFT算法，用于实现离散傅里叶变换，包括是否加零优化。,Classic FFT
police_wagon
- 利用51单片机和蜂鸣器发出警笛声，注释详细！-The use of 51 single-chip buzzer sounded and the whistle sound, detailed notes!
ADC10
- msp430F2274的adc10功能转换程序，内含dtc的设置，通过iar调试通过。-adc10 function of msp430F2274 the conversion process, including setting dtc through debugging through iar.
xt3
- 编写串口通信程序，要求PC机先发送02H，单片机发送“HELLO”，如果PC机发送55H，单片机发送“THIS IS A WELL BEGIN!”-Procedures for the preparation of serial communication, PC-request sent to 02H, single-chip microcomputer to send "HELLO", if the PC sent 55H, single-chip microcomputer Send "T
HX8340_TM_initial
- HX8340_TM_initial初始化-HX8340_TM_initial.txt
TEST
- 通过矩阵键盘输入，液晶1602或是12232显示某特定值-tongguojuzhenjianpanshuru，yejing1602 or 12232 display
DA
- 10位DATLC5615通过设定可以设定想要输出的电压-10 DATLC5615 by setting the desired output voltage can be set
PIC16F887--PWM-with-50khz
- 单片机16f877输出方波 50HZ 可以根据自己的使用调节脉宽和频率-Microcontroller 16f877 50HZ output square wave can be adjusted according to their width and frequency of use
main
- 主要功能是实现单片机的串口通信方便在程序调试的过程中可以通过串口助手观察结果。-SCM' s main function is to facilitate serial communication process of debugging assistant through the serial port observations.
uart
- 。任何UU编码行的长度都不应超过61个字符（字节），即它可以保持45个数据字节。当数据少于20个UU编码行时，校验和按照实际发送的字节数进行计算。主机将它与接收字节的校验和相比较。-. The length of any UU-encoded line should not exceed 61 characters (bytes), that it can hold 45 data bytes. When the data line less than 20 UU encoding, verif
mini2440_gpio_module.c.tar
- mini2440的gpio口驱动程序，可以驱动gpio输出高低电平-mini2440 s gpio port driver, it can be drive gpio to output high low voltage
fm25cl64
- stm32读写铁电存储器的程序,经测试可以用-stm32 ferroelectric memory read and write, the test can be used