资源列表
led
- 可以点亮信号灯。通过高低电平的控制,来实现灯的亮灭-Lights can be lit. Through level control to achieve the bright lights out
hongwai
- 51单片机红外遥控驱动程序,用Keil4写的。-Infrared remote control 51 single chip driver, with Keil4 written.
AD7705CFile
- AD7705在51单片机中的应用,代码已经调试通过并大量应用,该芯片精度还可以1LSB,只是采样频率比较低.-AD7705 in the 51 SCM application, the code has been debugged and the large number of applications, the accuracy of the chip can also be 1LSB, but the sampling frequency is relatively low.
8255
- 8255交通灯设计 微机原理与接口技术实验-8255 traffic lights design
12
- vc 与单片机通信 vc 与单片机通信 vc 与单片机通信-vc port vc vc port vc vc port vc vc port vc
megaeeprom
- ATMega16 EEPROM control
C51_LCD1602
- AT89C51/52单片机驱动字符液晶屏LCD1602的程序,已经封装好,直接在工程中添加LCD1602.C文件,并且在主函数中#include LCD1602.H-AT89C51/52 Microprocessor character LCD LCD1602 procedures are packaged well, directly in the project to add LCD1602.C file, and in the main function# include LCD1602.
74hc166
- stc11f16xe与74HC166的通讯-stc11f16xe communication with 74HC166
Dig-scan
- 数码管动态扫描,应用于AT80C51单片机。-Digital control of dynamic scanning, used in the AT80C51.
test
- AVR单片机的定时器中断程序,用来控制数码管显示数字,可以在ICC软件中编译通过。现在到AT16单片机中运行-The timer interrupt program of the AVR microcontroller used to control digital display digital, you can compile in the ICC software through. Now run to the AT16 microcontroller
msp430g2xx3_ta_02
- MSP430定时器实验,当定时时间到达时,指示灯改变状态,实现闪烁效果。-Descr iption: Toggle P1.0 using software and TA_0 ISR. Timer_A is configured for up mode, thus the timer overflows when TAR counts to CCR0.In this example CCR0 is loaded with 50000. ACLK = n/a, MCLK = SMCLK = TACL
a
- p3.0-p3.4 为按键 左转 右转 前进 后退 停止。 p1.0-p1.3 步进电机1 p2.0-p2.3 步进电机2 五按键控制 ,可以不用按键,改为上位机控制。-p3.0-p3.4 for the forward and back buttons Zuozhuanyouzhuan stop. p1.0-p1.3 1 p2.0-p2.3 stepper motor stepper motor two five control buttons, you can