资源列表
three_coupling
- 三个耦合区的微环谐振器的滤波特性matlab仿真-Microring resonator filter characteristic three coupling region
yiqunsuanfa
- 基于蚁群算法的三维路径规划，有具体程序说明，图例。-Three dimensional path planning based on ant colony algorithm
LCR-Digital-Bridge-V2
- 许老师的数字电桥V2版本此版本为全自动版本实测最大误差0.28 ，大部分实测，误差为0.1 左右（即0.15 到0.05 之间） 最小分辨力：0.3mR，低阻固有误差2mR（一般在1mR以内） 相位误差：可能可以达到0.003这一级别，与STC版恒阻自动桥差不多。 频率：支持多频点100Hz，200Hz，400Hz，1kHz，2kHz，10kHz，很适合对音频器件扫频测试-Digital Bridge V2 version of this version many teachers
jcs-RBTS
- 基于交叉熵法的电力系统可靠性分析，需要输入测试系统数据才行哟！-Reliability analysis of cross-entropy-based power systems, test systems need to enter data for the job yo!
SUTONG_bridge
- 苏通大桥Midas桥梁有限元分析模型，可作为有限元分析所用-Midas bridge finite element analysis model of Su Tong Bridge, can be used in finite element analysis as
STATCOM_PI
- 采用载波移相和PI控制器的（电流前馈解耦）STATCOM仿真，电路拓扑为H桥级联，实现了直流侧电压的平衡控制-Using STATCOM simulation of carrier phase shift and the PI controller, the circuit topology for the H bridge cascade, the realization of DC side voltage balance control
SendPcapTool
- wireshark抓包数据回放工具，用于对IP数据进行回放测试。-resend ip data captured by wireshark etc.
yuandaima
- 包含三个源码分别是单脉冲测角的仿真，基于MMSE准则的自适应旁瓣对消，平面阵的三维天线方向图计算。-The simulation consists of three single-pulse source are angle measurement based on MMSE criterion adaptive sidelobe cancellation of the three-dimensional antenna, planar array of chart calculations.
PSO-BP
- pso-bp神经网络优化程序，可对多类故障进行分类。-pso-bp neural network optimization procedures, multi-fault classification.
SM4
- 国家商用密码管理局公布的标准国密算法SM4的算法实现哦-very good
ML_Basic
- 2D 最大似然算法（ML），用于二维阵列信号处理的的DOA估计-An implementation of 2D ML algorithm, which is used for 2D DoA estimation in array signal processing.
APFC-Boost
- 带APFC的Boost升压变换器在Matlab中的仿真实现-Boost converte with APFC simulated in matlab/simulink