资源列表
gamma
- 用于DSP中的图像矫正.原理是伽马矫正.可以参照灰度与伽马值的对应表-DSP for image correction. The principle is gamma correction. Grayscale and gamma reference value corresponding to Table
AT24C02
- AT24C02的使用实例，通过EEPROM向82C55写入代码使得LED灯按给出的代码显示-Examples of the use of AT24C02
Coherentsignal-subspaceprocessing
- 这是一篇关于宽带信号源的相干信号子空间法的经典英文文章-An article about CSS English
64X16DisplayInSixWays
- 64X16点阵的PROTUES仿真,六种显示效果切换,对点阵爱好者有很大的研究价值,拿来分享-PROTUES the 64X16 lattice simulation shows that the effect of the six switch matrix lovers of great research value, used to share ...
temp
- 基于PIC16F877 温湿度控制器原代码及原理图PCB图-PIC16F877 based on temperature and humidity controller source code and PCB schematic diagram
GPIORAM
- 英飞凌单片机开发板验证外部RAM读写数据是否正确 -Infineon Single-chip development board external RAM read and write data to verify the correctness of
TMP36
- 基于aduc834单片机的温度采集系统，温度传感器为TMP36,模拟信号输出,500mV代表0度，10毫秒1度-Aduc834 MCU-based temperature acquisition system, temperature sensors for the TMP36, analog signal output, 500mV on behalf of 0 degrees, 10 degrees ms 1
PCF8563
- pcf8563的应用程序，初始化，读取，没有中断，还有数码管显示-pcf8563
MyMotor
- 利用vc编写的通过单片机控制三个步进电机的程序，自动检测com口。-Vc prepared through the use of single-chip stepper motor control of the three procedures, automatically detects the com port.
Uart
- CC2430 zigbee无线网络，关于UART的应用实例。-CC2430 zigbee wireless networks, on the application of UART.
jckz
- PC机与数控机床通信系统，非常有用，可以使用-PC-communication systems and CNC machine tools, very useful, you can use
89c52
- 用定时器以间隔500MS在6位数码管上依次显示0、1、2、3….C、D、E、F，重复。-500MS interval timer to use in the six digits show the sequence 0,1,2,3 .... C, D, E, F, repeat.