资源列表
EP94Z1E-Schematics
- This the schematic of the EP94Z1E DEMO V1.O BOARD. This IC is usually used in HDMI to VGA converters.EP94Z1E is a Low Power HDMI/MHL Receiver with VGA/Audio outputs and embedded MCU. The chip accepts HDMI/MHL dual-mode input and convert the input sig
QX5278V0.01
- Buck Boost White LED Driver for Single 18650 Lion Battery Designed using Kicad PCB Software
PROJECT_renlian4.0
- 基于STM32F407实现人脸识别和指纹识别的考勤系统硬件设计。-Hardware Design of Time and Attendance System Based on STM32F407 for Face Recognition and Fingerprint Identification.
AD9268
- 用于AD9268芯片的功能实现，手册。该芯片是电路要正确，要配置SPI可以调节参数，比如dither，分频等，就必须引脚PDWN通过10K电阻接地(AD9268 chip for the realization of the function, manual)
boost
- boost电路拓扑，电力电子技术整流电路拓扑(Boost circuit topology)
CYUSB3014 and FPGA电路设计
- 基于FPGA和CYUSB3014的USB3.0接口的硬件电路设计(Hardware circuit design of USB3.0 interface based on FPGA and CYUSB3014)
spi
- 使用verilog语言实现spi传输协议(Using Verilog language to implement SPI transport protocol)
ADXL362
- 3轴加速度传感器ADXL362在MSP430上的驱动(Driver of ADXL362 for MSP430)
LCL逆变器双电流闭环有源阻尼
- LCL逆变器电容电流反馈和逆变器侧电流反馈有源阻尼(LCL inverter capacitor current feedback and inverter side current feedback active damping)
Norflash_readid
- 通过镁光官网下载Norflash模型，然后编写v文件进行读取id测试，最后下载到FPGA板子，可以验证FPGA外接的Norflash是否工作
浮点数加法ip
- 这是两个浮点数实现加法的ip，用于硬件描述语言。这是组内做机器人项目时自己编写使用的。
P10 LED
- 显示驱动p10 单色led屏，内容为七屏滚动，且pwm波调节亮度(Display drive P10 monochrome LED screen)