资源列表
leddisp
- 通过I/O模同步串口与74HC595进行连接，控制74HC595驱动LED数管显示-the I / O module with Bit synchronous serial port for connecting to control LED drive several Bit Display
KESHEPLC
- 通过PLC来与过程控制设备通信 控制过程控制设备的工作-KNAKNAN
isd4003C
- 可录放语音芯片ISD4003的放音驱动程序，是本人精心调试的结果，与大家分享-can chip ISD4003 voice recording and showing the audio driver, I was careful testing results share with you
GBASCREEN
- 这是一个关于在ＧＢＡ上显示文字的程序，如果大家有兴趣可以一看，现在给大家共享一下.-this is a GBA on the text displayed on the procedure, if you are interested, you should have a look now to share this.
spi
- 软件模拟SPI串行EEPROM控制时序的C程序，在DOS下用BC31编译
4luxianzeqi
- 一个4路选择器的东西 程序 源代码都在 大家可以看看是不是可以用用 帮帮忙吧-A 4-way selector source code things are not everyone can look at are can help out with it
test
- Testprogram TRF7960 test
VHDL
- 电子设计自动化软件下的3-8位译码器，触发器的VHDL 代码-Electronic design automation software under the 3-8 bit decoder, triggers the VHDL code
1
- 一个VHDL实现的测频计 LIBRARY ieee USE ieee.std_logic_1164.all USE ieee.std_logic_arith.all USE ieee.std_logic_unsigned.all ENTITY freq IS PORT( Fsignal : IN std_logic -- Rst : IN std_logic Gate : IN std_logic Ready : OUT std_lo
spi_interface_premier_slave
- verilog版的spi接口的slaver部分程序-verilog version of the spi interface slaver part of the program
key
- 基于STM32系列芯片的4*8矩阵键盘扫描程序，采用定时器消抖，扫描效率高。-4* 8 matrix keyboard scanning procedures based on the STM32 series chips , using timer to debounce , high scanning efficiency.
Photosensitive-sensor
- 光敏电阻器是利用半导体的光电效应制成的一种电阻值随入射光的强弱而改变的电阻器；入射光强，电阻减小，入射光弱，电阻增大。本程序是基于MSP430的光敏传感器的模块程序-Photosensitive resistor is made using the photoelectric effect of the semiconductor a resistance change with the strength of the incident light and the resistor The i