资源列表
AT24C04_demo
- 这是我在程控交换机中使用的C51读写AT24C04例子-this is my program - controlled switchboards used in the C51 example literacy AT24C04
51
- AT2401的读写程序，用于在89x51单片机上对at2401进行读写
874Lcd-ks0108
- MSP430f149_ks0108液晶显示程序-ks0108 yejing test
lockec_10
- 简单密码锁,适合初学者学习使用，本人也是初学啊，-easy lock
bl3
- arm平台，通过按键控制led灯亮灭驱动程序-arm platform, through key control led lights off driver
DAC1x8S085
- DACㄠ08匠085 配置，c语言，MDK-DACㄠ08匠085 config
5-18
- 程序要求从键盘取得一个十进制数，然后把该数以十六进制的形式在屏幕上显示出来。该程序运用了寄存器传递参数的形式。-Procedural requirements the keyboard to get a decimal number, and then the number to hexadecimal form displayed on the screen. The program uses the form of register transfer parameters.
ADXL 345 SPI
- Communicate adxl 345 with pic 16f877a
0801
- st7066控制器，背光灯可循环控制，真正可行，本人已试验过。-st7066 controller, backlight can be recycled lamp control, really feasible, I have tested.
HONGWAI
- 利用外部中断接受红外信号，定时器计时，红外信号高低电平时间不同，因而可以根据时间把信号分离出来，然后再六位数码管上显示出红外的信号-IR signals received by external interrupt, the timer, infrared signal high and low at different times, so the signal can be separated by time, and then six digital signals to display t
SSI-CJ
- 基于MSP430单片机 SSI 从机仿真接口程序-SSI slave MSP430 MCU-based simulation interface program
tlv2553 verilog
- tlv2553 verilog TI 的ad转换芯片 在modelsim 上进行波形仿真