资源列表
key-watchdog
- 此代码为键盘控制看门狗的51单片机C语言程序代码
TLC2543
- TLC2543的转换函数很简单的,只要根据自已的硬件电路改一下端口的定义就可以直接用
stepper
- AT89C2051驱动步进电机-AT89C2051 driver stepping motor.
DS18B20驱动程序(C语言)
- 功能:实现对DS18B20的读取 原理:单总线协议 注意:单总线协议对延时要求比较严格,此程序中采用的是11.0592M的晶振,如果使用其他的晶振请跟据DS18B20的资料修改延时参数-functions : to achieve DS18B20 read Principle : single-bus protocol attention : single-bus protocol to delay requirements more stringent, this procedure is u
DHT21
- 基于ATmage128的DHT21温湿度传感器设计主程序-Based on the DHT21 ATmage128 main design temperature and humidity sensors
ADC0832
- 传感器接口说明:从左到右依次为通道1,地,通道2 功能:在数码管上显示传感器接口通道2输入的电压 小数部分为7位,整数部分1位-Sensor Interface Descr iption: from left to right channel 1, and channel 2 functions: to show possession in the digital sensor interface channel 2 voltage input for the fractional part o
Matrix
- An big X moving from left to right displayed on the 8*8 matrix screen. It simply used the 89c51 and only P1 & P2 port
steppermotorcontrol
- 基于AT89S52的单片机控制步进电机程序。可以实现正转、反转、正向加速、反向加速和停止功能-AT89S52 microcontroller-based stepper motor control program. Can be achieved is to switch, reverse, forward acceleration, reverse acceleration and stop function
tmpread
- 温度读取DS18B20读取温度值通过中断控制读取-temperature read
avr_I2c
- 这个资料是基于AVR M16芯片的I2C总线协议的实现程序。-This information is based on the AVR M16 chip I2C bus protocol implementation procedures.
dingshiqishizhong
- 单片机定时器设置时钟,外加矩阵键盘提取,同时键盘可自由修改时间-MCU clock timer settings, plus the keyboard matrix extraction, while the keyboard can be freely modified
fdmul
- 浮点乘法程序,适用于MCS-51系列单片机,汇编语言编写-Floating-point multiplication procedures applicable to the MCS-51 series microcontroller, written in assembly language