资源列表
vgactrl
- vga控制电路原码。主要有时序产生模块,彩条产生模块和接口模块。改程序主要用状态机来实现,两个计数器来控制状态的翻转。-vga control circuit original code. Sequencers have a major modules of exotic produce modules and interface modules. Procedures in the main state machine to achieve, two counter to the state
writing
- verilog 编写的时钟
flodiv
- 本程序实现PIC标准浮点数除法。 入口参数:被除数在ARGBH1:ARGBL1:EXP1中,除数在ARGBH2:ARGBL2:EXP2中。 出口参数:结果在ARGBH1:ARGBL1:EXP1中。 占用资源:W,STATUS,020H~02BH,两重堆栈。 说 明: 1.加载本文件的同时也加载了另外2个文件"DUSUB.ASM","DUADD.ASM" 故用户在使用这2个子程序时可直接调用,不必重新加载.- This program to achieve the
ds18b20
- 对DS18B20的介绍应用及编程方法的介绍。关于DS18B20的一般编程方法及应用的介绍。-DS18B20 application and presentation of programming introduction. About DS18B20 general introduction to programming methods and applications.
DS1302
- 单片机驱动时钟芯片ds1302,已在开发板调试成功-Microprocessor ds1302, debugging in development board
232
- max232与电脑连接的发送程序,电脑可以接收到单片机发送的数据-max232 connection with the sending computer program, the computer can receive the data sent to the microcontroller
51MCU-The-infrared-signal-analysis
- 基于51单片机的红外信号分析程序,获取的数据在数码管上显示的同时通过串口发送到电脑上,用于帮助并分析未知的红外信号.红外信号38khz.-51 MCU-based infrared signal analysis program to obtain data in digital display at the same time sent to the computer through the serial port, to help and analyze the unknown infrar
1
- 单片机流水灯代码 用于通过单片机控制LED灯闪烁 简单易懂-SCM water lights code for easy-to-understand through the microcontroller to control the LED light flashes
1616
- 16*32电阵,16 * 32 power array 16 * 32 power array -16* 32 power array,16* 32 power array16* 32 power array16* 32 power array
DSP28_EVPWM
- 利用DSP2812的EV功能产生PWM波形。其中调用了正弦表,采样96个点。-DSP2812 the EV function to generate the PWM waveform. Which is called the sine table, sampling 96 points.
ab6000
- This source was written for AB6000 chip. Communication Modbus by UART was designed. Source code war written in C language.
rgb
- 基于STM32单片机的RGB彩灯控制驱动代码(STM32 microcontroller based on RGB lantern control driver code)