资源列表
capture3
- DSP407A捕捉程序，CAP3中断
crccode
- CRC循环冗余检验 Verilog 编码程序
mult_piped_8x8
- 8位乘8位的流水线乘法器，采用Verilog hdl编写-8 x 8-bit pipelined multiplier, used to prepare Verilog hdl
12
- hdb3编码的 hdb3编码的-HDB3 coding HDB3 encoding
WS2051
- 通过89C2051单片机扩展8051单片机的通信接口，本例程就是利用89C2051单片机为8051单片机扩展了一个RS-485通信接口-89C2051 Singlechip through the expansion of the communication interface 8051, the routine is to use 89C2051 microcontroller 8051 to expand a RS-485 communication interface
statemachine
- RTL级verilog代码 用状态机实现 将输入数据写入16位寄存器，输出其除以7所得的余数（4位）-RTL-lever verilog code Using FSM to realize the following function:input the data into a 16bit register, divide it by 7, and output the 4-bit remainder
pll
- verilog硬件描述语言实现数字锁相环功能仿真,-Digital phase-locked loop using verilog
CORDIC
- 基于FPGA的CORDIC数字计算机的设计-CORDIC FPGA-based design of digital computers
password-locker
- 简单的单号密码锁程序 在verilog上实现 包括测试程序-simple password locker programme based on verilog, which including test bench
4
- 8x9FIFO逻辑功能的VHDL语言程序，程序中定义了四个进程，用来寄存数据，控制读指针，控制写指针以及控制三态输出-VHDL language program for 8x9FIFO logic function, the program defines four processes for data storage to control the read pointer to control the write pointer as well as to control three-stat
counter
- 本程序为计数器的基本驱动示例，计数器工作于方式1。对按键S2按下的次数进行计数，当计数记到3时，第一个发光二极管被点亮。-This program is an example of the basic drivers of the counter, the counter works in mode 1. Press button S2 for counting the number of times when the count to three in mind, the first ligh
test
- STM32，内部温度传感器实验的简单编程，适合初学者-STM32, the simple programming of the internal temperature sensor experiment, suitable for beginners