资源列表
veriloguartrx
- verilogHDL编写的串口检测程序，自己写的，相对其他的代码，本程序比较简短，初学者容易掌握。
hdl-hw1-brent-kung-adder
- BRENT KUNG ADDER 4 bits
PWM
- 脉冲宽度调制(PWM)，是英文“Pulse Width Modulation”的缩写，简称脉宽调制，是利用微处理器的数字输出来对模拟电路进行控制的一种非常有效的技术-pwm
WXMKTEST
- 一个单片机的无线遥控接收模块，本程序是用c语言编写的-A single-chip wireless remote control receiver module, the program is written in c language
10s
- 10秒以内定时器的设计与应用，能应用于10秒以内的精确定时-Within 10 seconds the timer design and application, can be applied within 10 seconds of the precise timing
paixu
- 一个单片机的排序程序，希望可以跟大家分享。-A single chip sorting program, hoping to share with you.
lcd-1602
- lcd1602显示测试程序，适合51单片机，用p0口信号，p2.1p2.2p2.3控制-the lcd1602 display test program for 51 single-chip, with p0 mouth of signal, p2.1p2.2p2.3 control
1602LCD-lib
- 1602LCD驱动库，接口非常好。 适用51单片机，可移植到AVR上。-1602LCD driver library, the interface is very good. For 51, can be transplanted to the AVR.
ARM-4M1553_CS
- ARM中关于1553总线的设计开发代码,已经成功应用-ARM in the design and development about 1553 code
miaobiao
- 基于tx-1c开发板的两位数秒表，通过三个堵路按键来加数减数和重置。并通过数码管来显示 -Tx-1c development board based on two-digit stopwatch, through three Dulu and reset buttons to addend subtraction. And through digital displays
1602
- 1602的程序P1.1接RS，P1.2接en，P1.3接rw。P2.0~P2.7接的D0~D7。P2.6和P2.7这两个端口的SEL在复位以后默认是1，注意置0-Program P1.1 1602 pick RS, P1.2 then en, P1.3 pick rw. P2.0 ~ P2.7 pick of D0 ~ D7. SEL P2.6 and P2.7 of the two ports after reset default is 1, attention is set
lattice
- 汉字点阵指针驱动，用的74hc595芯片，偏移指针就可使显示移动。-Chinese character dot matrix pointer driver, with the 74HC595 chip, the offset pointer can be displayed on the move.