资源列表
2410_lyt
- arm_s3c2410无操作系统的源码－－－写linux驱动的好资料-arm_s3c2410 no source operating system Linux -- was driven by good data
vhdlshiyan
- 本文为采用VHDL编写的程序及报告。步骤如下：1设计三位二进制计数器程序 二:设计一驱动循环显示7位数字 2编写LED控制程序如下： 3设计采用原理图方式如下: -VHDL paper prepared for the introduction of procedures and reports. Steps are as follows : Design of a binary counter three two procedures : Design of a drive
QT2440_Test
- 研勤公司2440开发板的测试程序，包括所有s3c2440模块的测试，推荐下载-research service company 2440 development board testing procedures, including all s3c2440 module testing, download
Dial
- vhdl经典源代码——键盘接口设计，入门者必须掌握-vhdl classical source code -- the keyboard interface design, beginners must master
clock
- vhdl经典源代码——时钟设计，入门者必须掌握-vhdl classical source code -- Clock Design, beginners must master
PS2
- vhdl经典源代码——ps2接口设计，入门者必须掌握-vhdl classical source code -- ps2 interface design, beginners must master
dingshi
- 基于89S52单片机的4位led显示程序，采用定时器记数，最大定时为-89S52-based MCU four led display program, using timer counting, Timing for the largest
vga
- vhdl经典源代码——vga控制，入门者必须掌握-vhdl classical source code -- vga control, beginners must master
GumstixIICE6
- GumstixII系统的wince6.0的bsp，cpu是intel的xscale，压缩後是安装文件，安装后会在ce文件夹下产生原代码文件夹-GumstixII system wince6.0 the bsp, intel cpu is the xscale, is the installation of compressed paper, After installation in ce folder under the original code folder
cdingshi
- 基于89S52单片机的4位LED显示，定时程序，定时器初值可以在程序中修改。-89S52-based MCU four LED display, the regular procedures Initial timer in the process of change.
LCD
- vhdl经典源代码——LCD控制，入门者必须掌握-vhdl classical source code -- LCD control, beginners must master
buzzer
- vhdl经典实例——信号灯控制，入门者必须掌握-vhdl classic example -- to control lights, beginners must master