资源列表
mytcp
- 我自己写的一个tcp/ip的代码,很短,用的是vc来做模拟调试的,具体的运行是要在mcs51单片机上的,只有一个端口。具体请大家看程序吧!-I wrote it myself a tcp / ip code, in a very short, it was vc do simulation testing, the specific operation is to mcs51 MCU, only one port. Please refer to specific procedures!
平缝机控制代码
- 平缝机的单片机伺服控制系统源代码。本程序为用单片机控制永磁同步电机的低成本方案-sewing machine SCM servo control system source code. The procedures for the use of SCM control PMSM low-cost programs
remote
- ht47r20遥控程序,红外线载波输出频率这系统时钟的12分频,当系统频率为480KHZ,载波频率为40KHZ-ht47r20 remote control procedures, infrared output carrier frequency system clock frequency of 12 minutes, when the system frequency for 480KHZ, carrier frequency 40KHZ
bigTime
- dsp 5509a 的usb程序ATMEGA16单片机进行AD转换的源程序代码-dsp 5509a the usb procedures ATMEGA16 microcontroller for AD conversion of the source code
用AT89C2051设计超声波测距仪
- 本文介绍了AT89C2051单片机的性能和特点,并在分析了超声波测距原理的基本系统框图。该设计系统经校正后,其测量精度可达0.1米-This paper introduces the AT89C2051 performance and features, and the analysis of the ultrasonic distance measurement principle diagram of the basic system. The design of the system ca
mjmjmjaaa003
- 最新10位数字温度传感器AD7416驱动程序-latest digital temperature sensor AD7416 driver
mjmjmjaa002
- 用c51编写写的x25045的读写程序,-used to prepare written procedures x25045 reader,
mjmjaaa001
- 一个ADC0809和DAC0832的程序-a ADC0809 and procedures DAC0832
12mjmjaa
- at89C2051驱动步进电机的原理图和源码-at89C2051 stepper motor drives the schematic and source
MITSUBISHI software i2c
- 日立单片机实现IIC的的程序,由C语言写出,已经调试通过,可以放心使用-Hitachi MCU IIC of the process from the C language to write, debug, can be assured use
ZLG_CF驱动
- 非常容易移植的CF卡驱动程序,在LPC21XX下编译通过,支持UCOS-II.如果想移植到单片机下也非常容易,我就以此版本移植到51的MCU中.-very easy transplant CF card driver, in LPC21XX compiler, support UCOS-II. If you want to migrate to the next SCM also very easy, I would migrate to this version of the MCU 51.
一个VHDL实现的测频计
- 一个vhdl实现的测频计,开发环境为任何支持vhdl语言的厂商提供的开发环境 -VHDL achieve a frequency measurement of dollars, development environment for any VHDL language support for manufacturers of the development environment