资源列表
7219
- 该程序采用89C51单片机实现，利用MAX7219实现对数码管的控制。-The procedure used to achieve single-chip microcomputer 89C51, MAX7219 use of digital control to achieve control.
fet440_uart01_09600
- msp449的演示程序代码关于串口通讯测试-msp449 demonstration test program code on the serial communication
main
- msp430的DS18B20驱动程序，已做修改，可直接使用-The DS18B20 msp430 driver changes have been made, can be used directly
Music
- 此程序仅用于学习与有了！ 描述: 单片机播放歌曲《兰花草》-This program is only for learning and has been! Descr iption: SCM playing song " orchids"
FM25CL64
- 非常完整的铁电芯片FM25CL64驱动程序，带有校验-Very complete ferroelectric chip FM25CL64 driver, with a check
DS18B20
- MSP430单片机，温度传感器DS18B20程序。-MSP430 microcontroller, temperature sensor DS18B20 procedures.
CODE_AT89S52_LM335_8KENH_DEV1
- CODE_AT89S52_LM335_8 Chanel_DEV1
fifo
- This writes up to nbytes bytes to the FIFO If the head runs in to the tail, not all bytes are written The number of bytes written is returned
zb
- STM32下 绝对通用的IIC 程序 简单明了；性能稳定；需要CPU 工作在72MHZ 以下 超频的除外-Straightforward the STM32 under absolute generic IIC program stable performance need CPU overclocking 72MHZ following except
wdog
- 基于低功耗单片机msp430f5438a 的看门狗寄存器设置,复位间隔时间设置,手动复位设置-Based on low-power microcontroller msp430f5438a watchdog register is set, the reset interval time setting, manual reset settings
dac7728_unit
- DAC7728的控制程序，经过顶层封装程序，可对此代码进行参数配置，实现芯片控制输出的功能。-the verilog file of controlling DAC7728
main
- JXARM9-2410 数模转换实验主程序， 实现功能：，实现JXRAM9-2410与PC机的串口通讯，JXARM9-2410 UART0 <==> PC COM