资源列表
EV1527
- EV1527软解码，同时支持PT2262解码-EV1527 Software Decoding
Orthogonal coding
- 基于STM32的正交编码器设计与实现，包括原理图+PCB图+程序，可以显示正反转，转速，当前角度-Orthogonal coding based STM32 design and implementation, including schematic+ PCB map+ program, you can display rotating, speed, current angle
stm32-dl645-meter
- stm32读写DL645电表的子函数程序，独立封装，调用即可-stm32 Functions meter reading and writing program DL645, independent package, you can call
红外学习型遥控器C程序
- 本程序是51单片机实现红外遥控器学习功能的C代码，采用外部中断触发方法，能支持NEC协议，有基础的也可以修改少量代码，就能学习PT2262，HS1527等315M无线的学习遥控器
st7567-12864-test-code
- st7567驱动12864测试代码，包括各种测试画面，图片显示等，-St7567 drive 12864 test code
sht10
- 基于51单片机的sht10温湿度传感器设计PROTUES仿真及源程序代码-Based on MCU 51 sht10 temperature and humidity sensor PROTUES simulation and source code
J1939
- OBD II 汽车故障诊断之J1939源代码，适用于PIC18系列单片机，稍作改动可用于其它类型单片机-Module Features • Supports user-defined setup of CAN and ECAN parameters like baud rate, maximum message size, number of reception/transmission buffers. • Incorporates interrupt-dr
ReactivePower
- 无功功率补偿控制器设计实例 附带电路图和C程序代码-Reactive power compensation controller design example with circuit and C code
MyProject
- 基于stm32 的示波器程序 实现信号峰峰值有效值和频率的测量-Stm32 based oscilloscope program to achieve peak RMS signal and frequency measurement
WindFarm
- PSCAD软件对风电场（包括风机）建模仿真例程-PSCAD modeling and simulation software routines for wind farms
AD9850-sweep-frequency
- 基于AD9850的扫频程序，并通过NOKIA5110显示当前的频率值。用keil 4编译。-Based on AD9850 sweep program and displays the current frequency by NOKIA5110 value. Compiled using keil 4.
无线遥控开关
- 单片机学习，用单片机实现无线遥控开关，基于MCS51单片机-Single-chip learning, using single-chip wireless remote control switch, single-chip based on MCS51