资源列表
液晶相关的程序
- 图形点阵液晶模块相关的各种面板大小驱动程序。-graphics dot-matrix LCD modules related to the panel size driver.
c51源程序
- 一些实用的51单片机接口源程序，里面附有文档说明，很好的开发参考资料-51 microcontroller interface source inside with documents show that the development of good reference
μC／OS—Ⅱ FOR ATMega256
- μC／OS—ⅡV：2.80 对 ATMega256 单片机的移植程序代码。- C/OS- II V : 2.80 pairs ATMega256 SCM transplant procedure code.
I2C接口调试
- 使用主模式I2C向CAT24WC02写入10字节数据，然后读出校验，若校验通过则BEE发声，否则不断BEE。 基于ADS1.2-use the main mode I2C CAT24WC02 to write 10 bytes of data, and then read out the check, if the check is through BEE audible, constantly BEE. Based on ADS1.2
1117776355
- LCD1602驱动程序 采用c语言驱动lcd1602-LCD1602 driver language used c-lcd1602
s3cev40
- AT29C040在单片机中的应用不仅能使用户快速地实现所需功能，而且电擦除的方式为程序和数据的存储和更新提供了方便，随着闪速存储器器件朝着容量越来越大、工作电压越来越低、支持共同的接口标准的方向发展，闪速存储器硬件接口和软件设计将越来越容易。 -AT29C040 in MCU that the application enables users to quickly achieve the required functions, but also -- in the form of erasur
实验四定时器中断
- 定时器中断实验代码， 定时器3进行0.1秒定时，每0.5秒改变一次P2,P3口的值以产生走马灯效果。-timer interruption experimental code, three timers for 0.1 seconds regularly, every 0.5 seconds to change a P2, P3 to the values I have merry-go-round effect.
74hc165
- msp430f149读HC165（4片串联）。兼有串口发送程序-msp430f149 Reading HC165 (four series). Serial sent both procedures
8515
- 液晶19264驱动程序。显示一串字符。用AT8515L控制，经过调试成功-19,264 LCD driver. Showed a bunch of characters. With AT8515L control, after successful testing
adc12
- msp430f149的A/D转换。单通道单次转换和时钟模块操作的程序-msp430f149 A / D converter. Single-channel switch and clock module operating procedures
430键盘程序（用端口中断）
- msp430f149键盘中断程序，用端口中断。通过实验验证-msp430f149 keyboard interrupt procedures, using ports interruption. Experimental verification
5054
- x5054读写程序。用80S51控制。C语言，有助于了解存储器的读写-x5054 read and write procedures. With 80S51 control. C language, helps the reader to understand memory