资源列表
DS12887时钟芯片编程
- 利用程序中的函数，来读取时钟芯片的秒、分、时、日、月、年、世纪，亦能对其设置时间日期。-procedures for the use of function, to read clock chip seconds, hours, days, months, years, centuries, but also the date of its set-up time.
红绿灯
- 模拟交通灯，并带有数字显示的程序。初始时全为红灯，显示“HELLO”字样。然后交通灯以“红绿、红黄、绿红、黄红”四种状态做循环，而且黄灯会闪烁，每种状态都带有到数记时。当按下P3_2时，变成“红红”状态，并显示“STOP”字样！ -simulated traffic lights and figures with the procedure. When all of the initial red, shows that the "hello" words. Then t
洗衣机
- 通过不同的二极管亮，表示洗衣机的不同状态。如正转、反转、洗条、干衣。按下P3_3时，会停止。 -through different diode light, washing machines, said the different states. Who is changed, and turned around, washing, drying. Press P3_3, would cease.
显示0到F
- 利用串行驱动数码显示每位从0显示到F，到灭循环显示，要求1秒更新一次。-drive using serial digital display shows each from 0 to F, to eliminate cycle, a request updated seconds.
A07_液晶LCD显示
- Freescale HC08GP32单片机接LCD源程序-Freescale MCU then HC08GP32 LCD source
51单片机 Keil C 延时程序的简单研究
- 转载!希望大家喜欢.主要是介绍用C编的C51的延时程序.-reproduced! Hope you like them. Mainly introduces C51 C series of procedural delay.
EAD_20040
- 液晶显示模块MGLS20040的C51驱动程序-LCD module MGLS20040 the C51 Driver
中断
- MTP-K4的读卡程序和KS0108的显示程序-MTP - K4 reader procedures and the display program KS0108
2303
- 威帆电子的精密时钟SD2303的读写程序-Granville sails of the sophisticated electronic clock read and write procedures SD2303
视频切换器
- 一个使用C51编写的视频切换器的控制程序，用于16选4的视频切换-use C51 to prepare a video switcher control procedures for the April 16 elections Video Switch
下位机串口调试
- 自已编写的一个用于调试单片机串口的一个下位机程序。很实用的。-own prepared by a serial port for debugging MCU of a crew under the procedure. Very practical.
JHD19264LCD源程序
- 这是JHD19264液晶显示器的驱动源程序，单片机采用的是AT89C52.-LCD driver source, the microcontroller is AT89C52.