资源列表
littleyoda-DCC-Decoder
- littleyoda-DCC-Decoder (ESP8266 based decoder for model railway)
Marlin
- Optimized firmware for RepRap 3D printers based on the Arduino platform.
试跑程序
- 基于电磁感应的智能小车的试跑参考程序源代码(The source code of the running program of the intelligent car based on electromagnetic induction)
testproject
- 在Linux嵌入式实现各种图片解码，播放，如bmp，ping，jpg图片(Realize all kinds of picture decode, play)
control_DOBPos2
- this is arduino due code. im using rotary encoder on motor shaft and for add/reduce set point. the motor rotary encoder assigned in pin 2 and 3 arduino
多级菜单%2B按键切换
- STM32F103+LCD1284实现多级菜单(STM32F103+LCD1284 implements multilevel menus)
ESP8266_RTOS_SDK-1.5-project_template
- 将乐鑫官方提供的SDK工程裁剪为一个工程模板。其他的功能均可在这个基础上添加实现。属于空工程。(Lok Xin official SDK project will be cut into a project template. Other features can be added on this basis. Belong to the empty project.)
STM32 的4路互补pwm
- 使用keil5编写的STM32输出四路互补的PWM，适配正点原子的mini版，同样是为电赛逆变系统做的准备。通过定时器的输出比较模式，在PC6~PC9，输出4路PWM，每路PWM频率为500Hz，占空比为50%，每一路PWM相位差为45°(The STM32 output four complementary PWM, which is written in keil5, is suitable for the mini version of the positive point atom, w
stm32f4_project-读取波形
- 该程序基于STM32F4，实现读取波形的功能(The program is based on STM32F4 to realize the function of reading the waveform)
cortexamigafloppyemulator_v105a
- Updated cortex firmware for the gotek floppy drive hardware usb emulator
HC595驱动8位led的8051程序
- 51单片机通过HC595驱动8位数码管，用STC单片机实测可用(51 MCU drives 8 bit digital tubes through HC595)
DS1302_digitaltube
- arduino控制ds1302 读写数据(control ds1302 by arduino to write and read data)