资源列表
接触读写芯片PN512在读取身份证UID的源码及电路
- 接触读写芯片PN512在读取身份证UID的源码及电路(The contact read and write chip PN512 reads the source code and circuit of the ID card UID.)
ads1158配置
- 首先说明ADS1158命令读写模式，然后解析命令含义及配置顺序等。(First, the ADS1158 command read and write mode, and then parse the command meaning and configuration order and so on.)
222
- d f g r klk;lk;l oi iiiiee e eeeeeeeeeee o o o eeeeeee
LEDreg
- led driver controller untested
16F877X Bootloader
- Microchip PIC16F87x Bootloader/Downloader
PL2303驱动
- pl2302驱动1.用USB线连接学习板和电脑。随后会听到叮咚一声。并弹出一个对话框。 2.关闭该对话框。运行光盘中PL2303文件夹下 HL2303。按提示进行操作即可 3.安装成功后会在设备管理器 COM口选项中看到连接的COM口是多少 4.打开STC_ISP软件 选择芯片型号，COM口 5.切记 点击下载后冷启动下学习板。即关闭电源，在重新打开下(1. use the USB line to connect the learning board and the computer.
JLINK V8 固件恢复办法
- 是单片机工程师必备软件，JLINK固件恢复方法(The JLINK firmware recovery method is the necessary software for the single chip computer engineer)
Arduino-master
- arduino master library
ILI9481 stm32 LCD驱动
- ILI9481 stm32 LCD驱动ILI9481 stm32 LCD驱动ILI9481 stm32 LCD驱动ILI9481 stm32 LCD驱动ILI9481 stm32 LCD驱动ILI9481 stm32 LCD驱动
RT-thread-project-gathon
- RT-thread 2.1.1 移植到 STM32F103ZET6,周期点亮两个LED; 程序运行在RAM中，如果需要在flash中运行的,请自行在MDK的设置中修改; by gathon(RT-thread 2.1.1 ported to STM32F103ZET6,Cycle two LEDs, The program runs in RAM. If you need to run in flash, please modify it yourself in the settings
protus
- 通过单片机软件编程并用proteus硬件仿真的自动喂料(Automatic feeding of Proteus hardware simulation by software programming with single chip microcomputer)
Temperature_Sense_Demo
- MSP430g2系列采用ADC采样测量内部温度例程(MSP430g2 series using ADC sampling to measure internal temperature routine)