资源列表
LED-for-MSP430F1611
- LED for MSP430F1611 Use the IAR_embedded workbench
CEJU
- 基于单片机的超声波测距程序。主要由主程序，超声波发射子程序，超声波接受中断程序及显示子程序组成。基于单片机的超声波测距程序。主要由主程序，超声波发射子程序，超声波接受中断程序及显示子程序组成。-Based on Ultrasonic Ranging procedures. Mainly by the main program, subroutine ultrasonic emission, ultrasonic accept the interrupt program and display s
xiaoche4
- 采用嵌入式IAR工作台版:4.20主要应用代码设计为EXP4618板-IAR Embedded Workbench Version: 4.20 main application code is designed to EXP4618 board
freescale
- 本程序是为了第四届FREESCALE智能车大赛，舵机测试时使用的程序，基于51单片机实验版。利用C语言完成，仅供参考，欢迎批评意见，转载请注明出处。-SST89E58/SST89E516 Experimental BOARD Copyright(C) 2009, Shulin Liu, HUST All rights reserved. For Freescale Smartcar Match
read_sms
- This code is written for 8051 family. It will is a full code to reade an sms from a gsm engine using AT commands
zhangjialiang
- 每一步都有详细的讲解说明，简单易懂，功能强大，很好很强大-Each step in detail all that simple, powerful, good strong
rtu
- remote terminal unit designing on 8051 micro controller source code
stc12c5aAD1602
- stc12c5a60s2单片机关于ad转换程序。-some books of the stc12c5a60s2.
key_sub
- 项目中曾使用的键盘扫描的键盘的汇编代码，用在atmega128上。-The project had used the keyboard to scan the keyboard assembly code for use in atmega128 on.
GLCDThermoRTCclockAtmega16
- Clock with Atmega16 + DS1307 + DS12B20 + GLCD 128x64, writing in BASCOM
testframe
- VG9811计量芯片的测试程序，主要用来测试计量部分。-VG9811 measurement chip testing procedures, mainly used to test the metering section.
zigbee_networkAddress
- 本程序用于计算包括协调器在内的五层zigbee网络拓扑结构，输出格式为父节点网络地址/本节点网络地址/本节点类型。通过查询输出文件，可以根据节点网络地址查询zigbee网络拓扑。-This procedure is used to calculate the five-story zigbee network topology, including the coordinator, the network address of the parent node of the output form