搜索资源列表
slnr_sim
- 在matlab上对1×2的mimo-ofdm通信系统进行slnr仿真，仿真结果是对两种信道slnr预编码算法进行的比较。比较结果支持多数据流传输。SLNR_sim2.m为主程序。-In matlab on the 1 × 2 of mimo-ofdm communication system slnr simulation results is a two channel slnr comparison of pre-coding algorithm. Compare the results t
compare
- tcl脚本语言编写的，在ns2 2.9版本上，对aodv和dsr两个路由协议进行比较分析的代码-tcl scr ipting language written in the ns2 2.9 version of the AODV routing protocol and the two dsr comparative analysis of the code
ClusterProtocols
- 分析了无线传感器网络分簇路由机制,着重从簇头的产生、簇的形成和簇的路由角度系统地描述了当前典型的分簇路由算法,并比较和分析了这些算法的特点和适用情况.最后结合该领域当前研究现状,指出分簇路由算法未来的研究重点.-Analysis of wireless sensor network clustering routing mechanisms, focusing on the selection of cluster head, cluster formation and cluster rout
RUNE_multicast
- 这是一个基于matlab/RUNE环境的移动通信网络仿真程序包，用于科研或教学用途，可以仿真比较GPRS网络中的单播和组播的性能。-This is based on matlab/RUNE environment of mobile communication network simulation package, for scientific research or teaching purposes, you can compare unicast and multicast perform
Interference-Suppression-Techniques-in-MIMO-Cellul
- 对传统的多小区系统中的干扰控制技术进行了简单的回顾,对多用户和多用户MIMO系统中的干扰抑制技术进行分析，这些是后续对多小区MIMO研究的基础。重点对多小区MIMO系统展开深入研究，揭示了系统干扰受限的原因，将单用户和多用户的千扰抑制技术扩展到多小区系统，分别给出了基于接收端和发送端的多种抑制干扰的系统结构和算法，推导了其容量并进行了性能分析。同时也结合实际系统的设计对各种干扰抑制技术进行比较和评价，得到了许多对于系统设计具有参考价值的结论。-he traditional system of m
RAKE_BER_CONVENC_QPSK
- *Demonstrate convolutional encoding and decoding *Simulate BER for QPSK and BPSK, plot and then **compare the result with the theoretical value. *compare SER of the Rake and ML. – Symbols are taken randomly from QPSK. – Run the simulation for
channel-simulink
- 衰落信道幅值仿真编程：对瑞利衰落信道进行仿真，并加上高斯白噪声，通过输入不同的信噪比 比较其误码率变化-Amplitude fading channel simulation programming: on the Rayleigh fading channel simulation, and add white Gaussian noise, by entering a different signal to noise ratio to compare their error rate ch
seqnum-compare
- 使用压缩感知进行信道估计的仿真代码，论文已经发表于I-channel estimation using CS theory,paper has been published in IEEE
DPSK-and-QPSK-and-OQPSK
- matlab /simulink完成DPSK,O QPSK信号的仿真分析对比-compare the DPSK、OPSK、OQPSK with matlab/simulink
liulab
- 对比SISO和SIMO系统的覆盖率,由此说明为什么用MIMO系统可以提高系统的性能-compare the location of users in outage of SIMO and SISO
lium
- 首先对比不同的均衡方法（ZF和MMSE），然后针对MMSE比较在不同的室内信道中的性能（ ITU Pedestrian B Model和 ITU Pedestrian B Model）-Compare the performance of different indoor channel modle(ITU Pedestrian B Model and ITU Pedestrian B Model）
zf_mmse
- mimo下行的线性预编码，分别基于ZF准则和MMSE准则,分别对基于zf准则的线性预编码和基于mmse准则的线性预编码进行比较-mimo downlink linear precoding, respectively, based on the ZF criterion and the MMSE criterion, respectively zf criteria based linear precoding and the linear pre-coding based on mmse cr
carrier_frequency_model
- 针对OFDM系统中的频偏模型进行建模，并比较OFDM系统在不同频偏下的误比特率性能。-Making the frequency offset moddling for the OFDM system and then compare the bit error rate performance under different frequency offset.
ofdm
- OFDM系统的信道估计技术，包括信道仿真以及LS算法和MMSE算法的优劣比较-OFDM system channel estimation techniques, including the LS channel simulation algorithm and compare the pros and cons MMSE algorithm
main
- We formulate a scheduling problem that takes into account different hardware delays experienced by the secondary users (SUs) in a centralized cognitive radio network (CRN) while switching to different frequency bands. We propose a polynomial-time
OFDM_MATLAB
- 比较完成的OFDM系统仿真接收端采用的算法和程序流程与发送端发送的OFDM符号的帧结构有关系。具体的帧结构，以及定时估计，频偏估计，剩余误差跟踪的算法可参考算法说明文档。-Compare completed received OFDM symbols OFDM system simulation algorithms and program flow with the sender sends the end frame structure used in a relationship. Con
power-allocation-
- 单天线系统中的功率分配算法的性能比较,比较简单的入门级功率分配的程序-Compare the performance of single antenna system power allocation algorithm is relatively simple, entry-level power distribution program
Compare
- comparison of BER performance for mapping of turbo coding with 16QAM 64QAM 128QAM
compare_ccdf
- compare ccdf for different block sizes of papr reduction
MU_MIMO_DL_precoders
- In a MIMO system for ZF, MF, MMSE precoding three different criteria and filter simulation, and compare its different.