搜索资源列表
resv.4m2t
- 紅外發射與接收,用此來檢測障礙物,實現報警-Infrared transmitter and receiver, use this to detect obstacles and achieve alarm
Rx
- 51单片机红外发送端程序,载波频率38K,由单片机自动完成调制-Infrared transmitter 51 MCU program, the carrier frequency of 38K, done automatically by the MCU modulation
fm
- 基于单片机可调频的FM发射机,用数码管显示频率,含有原理图和pcb图,源程序,-Microcontroller-based FM FM transmitter can use digital display frequency, containing schematic and pcb map, source,
tx
- transmitter in using UART protocol
you_ran
- 串行UART接收,采用VHDL语言,供参考-Universal Asynchronous Receiver/Transmitter
NRF24LE1
- nrf24LE1低功耗发射例程,调试通过,简单易懂,性能稳定。KEIL开发环境-nrf24LE1 low power transmitter routines, debugging, easy to understand, stable performance.
STC_SI4432
- 自己使用STC单片机调的一个无线发送模块和打卡器的源代码,亲测可用,按键发送固定的数组。- STC microcontroller tune yourself using a wireless transmitter module and the punch of the source code, pro-test is available, the button sends a fixed array.
msp430g2xx3_uscia0_uart_07_9600
- Descr iption: This demo connects two MSP430 s via the I2C bus. The master // transmits to the slave. This is the master code. It continuously // transmits 00h, 01h, ..., 0ffh and demonstrates how to implement an I2C // master transmitter sendin
msp430g2xx3_uscib0_i2c_05
- Descr iption: This demo connects two MSP430 s via the I2C bus. The master // transmits to the slave. This is the master code. It continuously // transmits 00h, 01h, ..., 0ffh and demonstrates how to implement an I2C // master transmitter sendin
chaoshengboceju
- 主要由单片机系统及显示电路、超声波发射电路和超声波检测接收电路三部分组成。采用STC89C51来实现对CX20106A红外接收芯片和7404的控制-Mainly by the SCM system and the display circuit, ultrasonic transmitter and ultrasonic detection circuit receiving circuit consists of three parts. STC89C51 to achieve the CX2
uart_tx
- uart transmitter module in verilog hdl
Stm32Usart
- 通用同步/异步串行接收/发送器 USART是一个全双工通用同步/异步串行收发模块,该接口是一个高度灵活的串行通信设备。-Universal Synchronous/Asynchronous Receiver/Transmitter USART is a full-duplex universal synchronous/asynchronous serial transceiver module, the interface is a highly flexible serial co
hongwaifasheyuanli
- 通过红外发射接收闪烁LED,同普通LED显示程序相同。由于主板集成了红外38K调制,所以只需发送需要发送的码即可-Via infrared transmitter receiver flashes LED, LED display program with the same ordinary. Since the motherboard integrated infrared 38K modulation, so you can just send the code to be sent
main
- UART通用异步收发机,在51单片机上实现控制异步通信- universal asynchronous receiver-transmitter
bianma
- 红外通信发送端,编码语音信号和温度信号,已经经过调试-Infrared communication transmitter, coded speech signal and the temperature signal, has been commissioning
AT89S51-microcontroller-produced-
- 用AT89S51单片机制作红外电视遥控器 一般红外电视遥控器的输出都是用编码后串行数据对38~40kHz的方波进行脉冲幅度调制而产生的。 用AT89S51单片机制作红外电视遥控器 当发射器按键按下后,即有遥控码发出,所按的键不同遥控编码也不同。这种遥控码具有以下特征: -AT89S51 microcontroller produced by infrared TV remote control TV remote control infrared output are
ask_transmitter_pcb_layout
- transmitter pcb layout file is created with protues based on ask 422 module
FMSPI
- EM78P153源代码,含24C02,I2C,以及1418FM发射模块控制部分!-EM78P153 source code, with 24C02, I2C, and the 1418 FM transmitter module control part!
FM_GTG602_rs300
- 主控芯片RS300A 的GTG602模块 FM调频发射源程序-Master chip RS300A the GTG602 FM transmitter module FM source
TelecontrolCar
- 51单片机遥控小车发送端、接收端程序,无线模块使用NRF24L01-51 single remote control car transmitter, receiver-side program, wireless module NRF24L01