搜索资源列表
Jflash.tar
- 利用PC的并口做的JTAG接口，向基于S3C2410A系统的Flash芯片烧入bootloader的程序源码。-use of the PC parallel port JTAG interface done to the system based on S3C2410A burned into the chip Flash Bootloader procedures source.
PARPORT_s3c2410
- 我为S3C2410写的扩展并口驱动程序，已经编译运行通过，附带内核配置文件。-S3C2410 I write for the expansion of parallel drivers, has been running through the compiler, kernel configuration file attached.
linuxpara
- 一个基于s3c2410嵌入式系统的并口实验（包括驱动程序和测试程序）-s3c2410 an embedded system based on the parallel experiments (including drivers and test procedures)
mrua_EM8622L_2[1].8.2.0_dev.arm.nodts
- 1. 8623L平台，其并行flash已经被烧入uClinux系统，并有IP地址. 2. Windows客户机,使用tera term通过串口,把kernel烧到并行flash上,用命令boot rom启动uClinux并且登陆. 3. Linux服务器，主要作用是编译软件,有nfs服务，nfs服务目录是/nfsdir,文件包括有8623L的驱动程序,应用程序和音视频文件,可以被8620L使用. em8623的开发包-1. 8623L platform, and its paral
EXAM
- 并口转USB控制芯片CH374的硬件定义，以及硬件操作注释。注释为中文。-Parallel to USB controller chip hardware CH374 definition, as well as the hardware to operate the Notes. Notes for the Chinese.
danpianji
- 单片机课程实验 实 验 一：仿真软件keil及protues的使用 单片机I/O并行接口的使用 定时/计数器 实 验 四： 中断 实 验 五： 串行通信-Microcontroller Course Experiment 1: simulation software keil and protues use of microcontroller I/O parallel interface using the timer/counter Experiment 4: Interrupt test
NVIDIA_CUDA_Programming_Guide_2.3.pdf
- NVIDIA 图形卡并行CUDA编程资料-CUDA Parallel Programming NVIDIA graphics card information
jlink_write_nand
- 修改过的uboot可以用于jlink烧写2440 autoboot和uboot 方便无并口设备开发-Modified uboot can be used to program the 2440 autoboot and uboot jlink facilitate the development of non-parallel device
pport
- Parallel Port driver for wl500g can be applied to any other router. Called from command line pport pin# [0/1]
usbkey_TEXT
- USB即Universal Serial Bus，中文称“通用串行总线”，是由Compaq、IBM、Intel、Microsoft、NEC和Northern Telecom七家公司于1995年所研发与规范出来的，随着近几年的推广与应用，USB已经成为个人计算机的标准的外设接口，并将逐步取代所有的各种传统外围接口，如串行端口、并行端口以及游戏接口等。-USB is Universal Serial Bus, Chinese as the " Universal Serial Bus&quo
acoral_linux
- 这部分代码是基于多核aCoral平台开发的，JPEG多核编码并行库-This code is based on the development of multi-core aCoral platform, JPEG encoding multi-core parallel library
VocalControl
- The code uses lirc code to control a TV and drives the outputs of parallel port to activate mechanical movements.
proc5
- 基于MAX527的并行DA转换源代码，有一定的参考价值-MAX527-based parallel DA converter source code, has some reference value
ssd2828
- The SSD2828 IC is an MIPI master bridge chip that connects an application processor with traditional parallel LCD interface and an LCD driver with MIPI slave interface. The 2828 supports up to 1Gbps per lane speed with maximum 4 lanes using both
8539695426
- STM32F103编写5寸LCD显示，分辨率854*480，SD卡储存字符编码，并口模式-STM32F103 preparation of 5-inch LCD display with a resolution of 854* 480, SD card storage character encoding, parallel mode
ST7567_driver
- ST7567 lcd驱动，文件里面包括了Datasheet，和驱动代码-ST7567 is a single-chip dot matrix LCD driver which incorporates LCD controller and common/segment drivers. ST7567 can be connected directly to a microprocessor with 8-bit parallel interface or 4-line serial inte