搜索资源列表
CAN
- 这个例程演示怎么用CAN外设和模数转换器 将ADC采样到的值通过CAN1 发送到CAN2 同时显示在LCD上，调节VR1将在 LCD上看到发送值和接收到的值同步。 硬件上将 CAN1L CAN1H 用导线分别连到CAN2L CAN2H上。-The CAN example is available in different targets: Simulator: - configured for software Simulator MCB1700: -
Work
- W5200 MCU:stm32F103C8 例程 环回口测试-W5200 MCU: stm32F103C8 routine port loopback test
CAN
- 基于stm32 can通讯的程序 主要是回环检测的程序 后面会提供两个板之间的通讯-Based on the stm32 can communication program Mainly behind the loopback detection program will provide the communication between the two plates
test
- stm32 can总线测试，采用回环方式编程，可以直接运行-stm32 can bus test, using loopback mode programming can be run directly
107can
- stm32f107can收发程序，波特率为500k，回环模式正常模式均可以正常工作，波特率可以自己修改，发送数据长度，id都可以修改。-stm32f107can transceiver procedures, the baud rate is 500k, loopback mode Normal mode can work, you can make changes to the baud rate, transmission data length, id can be modified.
NfcrdlibEx6_EMVCo_Loopback
- This example is a LoopBack Application which is used to perform EMVCo2.5(L1) digital compliance validation. -This example is a LoopBack Application which is used to perform EMVCo2.5(L1) digital compliance validation.
NfcrdlibEx7_EMVCo_Polling
- - NfcrdlibEx7_EMVCo_Polling can be run with PNEV512B, CLEV663B, PN5180 and PN7462AU. (See Section-10 for supported versions) - This example performs the EMVCo Polling loop. - Upon activation of the detected card, the example shall send a Sel
socket
- Pineapple is a very tasty fruit.