资源列表
smg
- 秒表计数,在c51单片机上用键盘控制,启停秒表,用于数码管显示-Stopwatch counting, in the C51 single-chip using the keyboard control, start and stop the stopwatch used in digital display
interruput
- 单片机中断、定时器和键盘配合操作的实验程序-MCU interrupt, timer and keyboard with the operation of the experimental procedure
abc
- 利用动态扫描和定时器1在数码管上显示出从765432开始以1/10秒的速度往下递减直至765398并保持显示此数,与此同时利用定时器0以500MS速度进行流水灯从上至下移动,当数码管上数减到停止时,实验板上流水灯也停止然后全部开始闪烁,3秒后(用T0定时)流水灯全部关闭、数码管上显示出“HELLO”。到此保持住。 -Dynamic scan and Timer 1 in the digital pipe shows start from 765 432 to 1/10 sec down an
ir
- 红外线控制程序,能够在51单片机上实现红外接收头与控制器的通信-Infrared control procedures, to achieve the 51 single-chip infrared receiver on the communication with the controller
pp51
- 1602液晶显示程序例程,开发板的配套程序,想自己玩的可以自己设计一个咕~~(╯﹏╰)b,这个是杭州晶控的,分享给大家。-1602 LCD display routine, the matching process development board, to their own design can play a goo ~ ~ (╯ ﹏ ╰) b, this is Hangzhou, crystal controlled, and share with everyone.
systest2
- 8051单片机模数转换测试程序(北工大版).-ADC 8051 test procedure (Beigong Edition).
chuang
- 用51单片机对7113初始化和控制,用单片机初始化7113的主要任务是程序的编写,然后根据7113的寄存器操作格式写出读写寄存器的程序,最后根据以上的子程序写出初始化7113的程序段。-7113 Microcontroller with 51 initialization and control, with the single chip initialization 7113 of the main task is to write the program, then operating un
tuowei
- 可以拖尾的8位流水灯,非常好看,已经调试通过,89s82-Water can be 8-bit tail lights, very nice, has been through debugging, 89s82
tc1902
- 红外tc1902的控制程序,实现按键按下,led灯亮灭变化-Infrared tc1902 control procedures to achieve key press, led lights off changes
SPI_finalVersion
- 此程序是针对arduino的SPI 三轴磁传感器编程。可以直接使用。-This program is for arduino programming the SPI-axis magnetic sensor. Can be used directly.
i2c
- i2c protcol,plc2132,ms-51,etc.
13MR
- STC11F02E单片机输入点启动延时输出,控制设备起停。-Microcontroller input start-up delay output control equipment starts and stops.