资源列表
rs_enc
- 这是一个用VHDL编写的RS信道编码程序-This is a VHDL prepared with RS channel coding procedures
movedata
- 按照一定格式把一段数据放在内存上，然后输出在屏幕上-my asm
ad574
- 利用状态机实现ad574的驱动程序，思路还是比较清晰-Using the state machine to achieve ad574 driver, thinking it is quite clear. . . .
I2C
- 基于LYS-51开发板的IIC总线驱动，包括读字节，写字节，开始，停止，应答函数。可用于驱动IIC总线上的设备。-LYS-51 development board based on the IIC bus driver, including read-byte, write byte, start, stop, response function. Can be used to drive the device on the IIC bus.
24LCXX
- PIC子程序，用于方便查找，减少编程时不必要的时间浪费。-PIC subroutines for easier access, to reduce unnecessary waste of time programming.
PWM-DA
- 本程序实现用PWM方式实现DA转换。 入口参数：待转换数据在SOU中。 出口参数：RC2引脚上输出PWM波,在4MHZ主频下，频率为3.9KHZ。- This program to achieve the realization of DA converter with PWM. Entrance parameters: the data to be converted in the SOU. Export parameters: RC2 pin of PWM
lcd
- 1602LCD测试显示程序，采用C语言编写-1602LCD test display program using C language
8LED
- 开关控制循环点亮LED 三种方式:跑马灯 流水灯 弥红灯-Switch control cycle light LED three ways: Marquee indemnity red light water
source
- 1602液晶驱动程序，详细源代码 。1602液晶驱动程序，详细源代码-1602 LCD driver, a detailed source code. 1602 LCD driver, a detailed source code
delay
- c程序，基于单片机，用于开发，很有用的源代码。- c program, based microcontroller, for the development, very useful source cod
bujin.c
- 验证并实现了C51单片机驱动步进电机正反转及调速功能。-Verified and implemented C51 microcontroller drive stepper motor and speed control function.
MCS51UART
- 自己写的51单片机串行口与PC机通信程序，汇编语言实现-Write your own 51 microcontroller serial port and PC communication program, implemented in assembly language