资源列表
LEDDSQ
- 这是针对单片机利用定时器通过延长定时方法实现灯的闪烁的汇编程序-This is for single-chip timers by extending the use of regular methods of flashing lights assembler
speaker.C
- 基于51的警车鸣笛声-speaker
liushuideng
- 独立键盘控制流水灯。短击加一，长击快加。-Duli jianpan kongzhi liushuideng.Duanji jiayi,changjikuaijia.
add
- 点亮并关闭发光二极管,点亮并关闭发光二极管-open light
DCMOTERCONTROL
- 5V直流电机调速控制 实现三档调速 正反转 H桥驱动 模拟PWM波控制 -5V DC motor speed control to achieve third gear speed reversing H bridge driver controlled analog PWM wave
pwm
- 52单片机电机pwm调速功能，c程序可以用l298等芯片控制调速-52 single-chip motor pwm speed control function, c chip program can control the speed with l298, etc.
Text4
- P1口做输入口，接八个拨码开关，以P0口做输出口，接八只发光二极管，(1)编写程序使发光二极管循环点亮。(2)读取开关状态，在二极管上显示出来。 1、根据要求设计接口电路的接线。 2、编写程序使发光二极管循环点亮，时间变化间隔0.5秒 3、编写程序读取开关状态，在二极管上显示出来。 - #include <reg51.h> #define LED P1 //宏定义,使用LED代替P1口(相当于LED=P1) #define ucha
liushuiseng
- 基于51单片机流水灯从上到下流再由下到上流最后闪五次-Based on 51 single-chip light water flows from top to bottom and then from five down to the high end flash
MSP430_AD
- 关于MSP430针对内部单路AD采集程序，已调试成功，请放心使用-About MSP430 single AD for internal collection procedures have been successful debugging, please rest assured to use
mux3_case
- implementation of multiplexer using case statements in verilog
coder_8_3
- 8 - 3 线 优 先 编 码 器 。高电平有效，高位到低位置位。高位优先级高于低位-8 3 line priority encoder. Active high, high to low bit. High priority than low
interpolate4
- 调制信号后4倍内插的verilog代码，用于基带成型滤波器输入数据-4 times after modulation signal interpolation verilog code, used to baseband shaping filter input data