资源列表
用8031加载FPGA
- 使用8031单片机加载FPGA的源代码,为FPGA的加载提供了另一种方便的方法.-use FPGA 8031 load the source code for the FPGA loaded provide another convenient way.
ref-sdr-sdram-verilog
- 本代码是用VRILOG语言写的SDRAM的控制器的标准代码,供开发SARM参考.-this code is used to write the language VRILOG SDRAM controller standard code for the development of SARM reference.
FAT16 磁盘格式引导程序(ASM)
- FAT16 磁盘格式引导程序.文件是以ASM汇编格式提供的.-FAT16 disk boot format. ASM is a compilation document format available.
关于cs5460的多篇资料
- 这是关于电能检测芯片CS5460的说明,里面有多篇中文资料,还有汇编语言例子.-This is the power of the CS5460 chip testing shows that more of Chinese inside information, there are examples of assembly language.
ArmJtag
- 在潜入市linux 下烧写vivi的原代码 arm上成功执行-sneaked into the city under linux burning anger of the original code arm on the successful implementation
8051 Counter 0 Example Program
- 8051单片机的计数器0的操作程序源代码-8051 0 counter the source code for the procedure
8051 Timer 1 Mode 2 Example Program
- 8051单片机的定时器1的控制程序，通过调用这个程序很容易实现对定时器的操作-8051 of a timer control procedures, by calling this procedure is easy to achieve the right to operate the timer
8051 Timer 0 Mode 1 Example Program
- 8051单片机的定时器0的控制程序，通过这个程序可以方便对定时器进行控制-8051 timers 0 control procedures, this procedure can facilitate the timer control
8051 Bit IO Example Program
- 8051单片机的IO口控制程序源代码，通过这个程序可以方便的操作IO-8051 IO population control program source code, through this procedure can facilitate the operation of IO
MCS96程序
- MCS96的源程序。用来给96单片机使用，采用汇编语言编写的-Processor of the source. Used to 96 microcontroller use, using assembly language prepared by the
2812CAN
- TI DSP2812 can总线程序,可以用这个程序设计can总线收发数据,已经在自己的开发板上测试过,运行良好-TI Bus DSP2812 can procedures can use this procedure can design data bus transceivers, in their own development board tested, well-functioning
ICMaster
- c51的程序示例，IC卡控制系统。其中包括硬件设计电路图和所有代码。-procedures example, IC card control system. Including hardware and circuit design all of the code.