资源列表
ucos-gcc-port
- 一个ucos-ii2.51移植到gcc下的port.大概是一个韩国人做的。从UCOS网站上那个VC的port改进而来。使用和介绍请见RAR文件中的注释。-an CENTER-gcc ii2.51 transplanted to the port. About a Korean done. UCOS site from which VC improvement from the port. The use and presentation of RAR see the Notes document
IAPatmega
- atmega128在线升级程序，自编程通过xmodem协议 -atmega128 online promotion procedures, since the programming agreement through XModem
SPLC501_LCD
- 8051单片机对SPLC501液晶驱动读写程序.c语言写的.很实用-8051 SPLC501 LCD driver to read and write procedures. C language written. Practical
Time0_T_Test
- ARM定时器0和1调试完整c和汇编程序 -ARM and a complete debugging and compilation procedures c
UART_ARM
- ARM lpc2129 串口传输数据c和汇编程序-ARM lpc2129 serial transmission of data and compilation procedures c
SPI_rec
- ARM LPC2129 SPI中断程序范例-LPC2129 ARM interrupt procedures example SPI
ADC01
- ARM LPC2129 AD中断范例 -LPC2129 ARM interrupted example AD
rtl81x9End
- 该文件是在VxWorks操作系统下的RTL8139驱动源码。-The document was under VxWorks RTL8139 driver source.
lgui_0.3.0.tar
- lgui是类似minigui的系统，功能非常不错 在-lgui MiniGUI is similar to the system, which is very good in
lGUI API参考手册
- lgui类似minigui的gui，国产，可用于嵌入式系统，-lgui similar MiniGUI the gui, homemade, can be used for embedded systems,
pcm
- 该程序设计了一个产生PCM码流时序信号的模块，他包括输入端CLK，SET及输出端Q1,Q2,Q3-the program have designed a PCM signal timing modules, including the CLK input, and output SET Q1, Q2 and Q3
codestream
- 设计一个模块，从一个窜行数据流里检测出码流“11100”，这个模块包括reset,clk,datain及输出端pmatch-design a module from a trip data flow channeling Lane detected bitstream "11100", this module includes reset, clk, datain and output pmatch