资源列表
99992
- 秒表程序-Stopwatch program
CS18-2
- 定时中断。采用定时器T0，定时50ms，每次定时溢出引起中断，在中断程序中对计数器累加。每一秒LED亮0.2s，熄0.8s。 特色：低功耗。程序中技巧在于将1s分成cnt记20次，0.2秒占20 ，即中断的前4次都点亮，后16次都熄灭。-Interrupted from time to time. The use of timer T0, from time to time 50ms, each caused by overflow from time to time interrupted
1602T
- 1602液晶程序,使用汇编程序编写！可以作为1602测试及学习用！-a program for 1602
dingshi
- //程序名称：dingshi.c //程序功能：定时器0驱动，流水灯显示定时中断次数-//Program Name: dingshi.c// process functions: Timer 0 drive, water lights show the number of timer interrupts
fre_pwm
- 可以调整频率和占空比的大小，用计数器来实现。时钟越高精度越好-FREQUENCE DUTY CYCLE
EEPROM
- Firmware written in Embedded C for implementing an I2C communication between a PIC16F877A with a 28Cxx EEPROM memory. However this can be modified to work on any controller platform.
ADE7753
- 基于LPC1114的ADE7753读写C文件-LPC1114 based on the ADE7753 to read and write C files
FREQ-COUNTER
- frequency counter in pic 16f877a
Print-table-(2)
- 打印乘法口诀表，每项的格式为：i * j = k，如： 1 * 1 = 1 1 * 2 = 2 2 * 2 = 4 1 * 3 = 3 2 * 3 = 6 3 * 3 = 9-Print multiplication formulas table format for each of: i* j = k, such as: 1* 1 = 1 1* 2 = 2 2* 2 = 4 1* 3 = 3 2* 3 = 6 3* 3 = 9
63
- 从8255的C口低四位输入一个BCD码，高四位也输入一个BCD码，两者相加后，以BCD码的形式从A口输出到指示灯。CS接280H。-From the 8255 low of C 4 I enter a BCD code, the high-four also enter a BCD code, the two add up to the form of BCD code output from the A to the light. CS then 280H.
ADC8C
- It is the program for ADC 8-channel for 8051.
encoder
- libs for encoder using -libs for encoder using