资源列表
IIR_filter_design
- IIR滤波器的vhdl语言设计的简单滤波器-vhdl for iir filter
c3
- 这是一个关于数码管接口电路的c语言程序，对编定数码管接口电路具有借鉴意义。-This is a digital interface circuit on the c-language program, scheduled on the digital control interface circuit with a reference.
lesson5_3
- 51单片机扫描4*4键盘后在数码管上显示例程-51 single scan 4* 4 keyboard routines in the digital tube display
0-f-xs
- 用一个led来动态显示从0到9的数和a到f的字母 实现加一计数-add one every time
bujinmada
- 步进马达正反转，C51,模块化程序可移植，-Stepper motor reversing, C51, modular portable,
lesson8
- 51单片机的I2C通信协议编程，，通过软件模拟I2C的方式实现I2C 的通信-51 MCU I2C communication protocol programming, through software simulation I2C I2C communication means to achieve
LED-D
- 基于STC89C52单片机实现LED的静态及动态扫描显示及处理的程序，适合初学值使用-STC89C52 MCU based static and dynamic scanning LED display and processing procedures, suitable for beginners to use the value
FIR
- 1、系统仅处于训练状态。训练序列为2cos(2π×f1×n/fs)， 干扰为sin(2π×f2×n/fs)；序列长度为100个样点。 其中n=0…99，f1=1kHz，f2=2kHz，fs=8kHz。 2、采用LMS算法，均衡器输入为训练序列加上干扰，均衡器阶数为21阶，步长因子β=0.01。 3、在Matlab中编写浮点LMS算法，绘制均衡器的输出波形，并与训练序列进行对比。 -1, the system only in the training status. The t
shuma
- 基于单片机89c51通过按键盘让数码管显示0到9-By pressing the keyboard 89c51 microcontroller based digital display allow 0-9
drawn1
- 用matlab读取txt文件然后画图，只需改变文件路径就可用-Read drawing using matlab txt file and then just change the file path can use
pwm08_07
- 采用51 模拟的pwmi/o口，代码简洁用外部中断响应快速，C语言编写方便易懂！-The 51 simulated pwmi/o mouth, concise code by external interrupt response, C language, easy to understand!
lcd16x2_keypad_8952
- lcd 16x2 keypad 4x4 89s52