资源列表
51-rs232
- 单片机RS232程序，看完一遍就理解串口通讯了-RS232 microcontroller program, read it again to understand the serial communication
lesson5_3
- 利用动态扫描和定时器1在数码管上显示出从765432开始以1 秒的速度往下递减直至764987并保持显示此数，与此同时利用定时器0以500MS速度进行流水灯从上至下移动，同时蜂鸣器发声，当数码管上数减到停止时，实验板上流水灯全部闪烁5次，数码管全熄灭。单片机进入休眠状态。 -Dynamic scan and Timer 1 on the digital display of 1 from the 765,432 begin to decline until the second speed
c3
- 这是一个关于数码管接口电路的c语言程序，对编定数码管接口电路具有借鉴意义。-This is a digital interface circuit on the c-language program, scheduled on the digital control interface circuit with a reference.
lesson5_3
- 51单片机扫描4*4键盘后在数码管上显示例程-51 single scan 4* 4 keyboard routines in the digital tube display
0-f-xs
- 用一个led来动态显示从0到9的数和a到f的字母 实现加一计数-add one every time
bujinmada
- 步进马达正反转，C51,模块化程序可移植，-Stepper motor reversing, C51, modular portable,
lesson8
- 51单片机的I2C通信协议编程，，通过软件模拟I2C的方式实现I2C 的通信-51 MCU I2C communication protocol programming, through software simulation I2C I2C communication means to achieve
LED-D
- 基于STC89C52单片机实现LED的静态及动态扫描显示及处理的程序，适合初学值使用-STC89C52 MCU based static and dynamic scanning LED display and processing procedures, suitable for beginners to use the value
shuma
- 基于单片机89c51通过按键盘让数码管显示0到9-By pressing the keyboard 89c51 microcontroller based digital display allow 0-9
drawn1
- 用matlab读取txt文件然后画图，只需改变文件路径就可用-Read drawing using matlab txt file and then just change the file path can use
pwm08_07
- 采用51 模拟的pwmi/o口，代码简洁用外部中断响应快速，C语言编写方便易懂！-The 51 simulated pwmi/o mouth, concise code by external interrupt response, C language, easy to understand!
lcd16x2_keypad_8952
- lcd 16x2 keypad 4x4 89s52