资源列表
main
- 一位LED显示的VHDL程序，挺简单的，买的开发板里面带的-An LED display of the VHDL program, quite simply, to buy development board inside the zone
I2Cstc89c52
- I2C总线程序，型号为stc89c52，晶振为11.0592M-I2C-bus program, model stc89c52, Crystal for 11.0592M
kaiguan
- 数字开关的小程序，可以实现电子自动开关。与一般的引脚设置不一样的是，这本身可以以至于程序的任意位置-Digital switching applet that can automatically switch to electronic. And general settings are not the same as the pin is in itself so the program can be anywhere
demo_8_2
- 同2N分频系统设计 基于AVR ATmega16单片机 利用T/CO的自动装载特性-2N frequency with AVR ATmega16 Microcontroller based system design using T/CO characteristics of the automatic loading
ggpdaima
- 广告牌程序的全部代码，显示5的程序，可以改动8*8的点阵显示不同的汉子-Billboard program all of the code, show the 5 procedures, can be changed 8* 8 dot matrix display a different man
toulanjifen
- 这是基于单片机用C语言写的，关于投篮计分系统的程序，自己的实验成果。-This is based on microcontroller written in C language about the scoring system on the shooting procedure.It is my experimental results.
164
- 串口方式0移位寄存器方式用于I/O口的扩展 164串并转换程序,00~99循环显示-Serial shift register mode 0 mode for I/O port expansion 164 series and the conversion process, 00 to 99 cycle
PWM
- 2.单片机中的PWM 指的是此单片机有部分I/O口具有输出PWM信号的功能。 比如说部分单片机的I/O口可以输出时钟信号，时钟信号的脉宽和占空皮可调，可以根据实际需要调整寄存器位来设定。 3.基本思想就是利用单片机具有的PWM端口，在不改变PWM方波周期的前提下，通过软件的方法调整单片机的PWM控制寄存器来调整PWM的占空比，从而控制充电电流。以此来调整亮度 -basic principle refers to apply PWM port
PDPINTB_ISR
- 故障中断服务程序，当电路出现故障时，会保护电路-Fault interrupt service routine, when the circuit fails, the protection circuit
juchibo
- 基于51单片机开发板，利用PCF8591将电压值进行A/D转换，在示波器上显示锯齿波-Based on 51 MCU development board, the use of the voltage value PCF8591 A/D conversion, displayed on the oscilloscope sawtooth
hwrtc_rx8025
- 时钟芯片rx8025驱动，I2C通讯方式，-Clock chip rx8025 driver, I2C communication,
motor-control
- L298通过pwm波驱动直流电机，电机为12v或者5v，是用51单片机开发的。-L298 pwm wave driven by a DC motor, the motor for 12v or 5v, with 51 MCU development.