资源列表
dct
- Discrete Cosine Transform
LED
- 这是一个用VHDL编写的LED显示程序,该程序虽然简单,但对一个初学的人来说也未必用不到,所以上传,希望能有人用到-This is a VHDL prepared with LED display program, the program is simple, but for a beginner who may not be less than, so upload the hope was to use
rotary_led
- module rotary_led(clk,reset,R_A,R_B,LED_DATA) input clk -module rotary_led(clk,reset,R_A,R_B,LED_DATA) input clk
hanmingam1
- VHDL语言的(7,4)汉明码编码的设计。-VHDL language (7,4) hamming code design.
f2341was
- programming for image modulation in vhdl code to enhance qualty
Program2
- 将8位待测预置数作为外部输入信号,即可以随时改变序列检测器中的比较数据。写出此程序的符号化单进程有限状态机。-The 8-bit pre-measured as the number of external input signal, which can change at any time in the sequence comparison of the data detector. Write the symbol of this process a single process fini
logic
- Verilog descr iption for cell logic
adder16_2
- 两个16位的二进制数相加,分别是高位和高位相加,低位和低位相加。-Two 16-bit binary numbers together, were added to high and high, low and low sum.
fsk
- 用Verilog语言在FPGA上实现FFT算法-With Verilog language FPGA to realize FFT algorithm
binary2bcd
- binary to bcd code converter design using verilog
Stepper-motor-speed
- 步进电机控制模块主要包括步进电机调速控制,该模块实现步进电机可由外置拨码开关来控制电机转速。-Stepper motor control module comprises a stepper motor speed control, the stepper motor module by external DIP switches to control the motor spe
interpolate4
- 调制信号后4倍内插的verilog代码,用于基带成型滤波器输入数据-4 times after modulation signal interpolation verilog code, used to baseband shaping filter input data